Onkyo TX-SR701 Owner Manual - Page 29
Connecting antennas
UPC - 751398005183
View all Onkyo TX-SR701 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Connecting antennas To use the tuner of the TX-SR701/701E/601/601E, it is necessary to prepare the supplied FM and AM antennas. • Adjustment and placement of the FM and AM antennas for better reception must be done while listening to a station broadcast. • If better reception cannot be obtained, then placement of an outside antenna is recommended. Assembling the AM loop antenna Assemble the loop antenna as shown in the illustration. • Refer to "Connecting the AM loop antenna" below for details on how to connect the loop antenna. Connecting the included antennas Connecting the FM indoor antenna: The FM indoor antenna is for indoor use only. During use, extend the antenna and adjust its orientation until the clearest signal is received. Fix it with push pins or similar items in the position that will cause the least amount of distortion. If the reception is not very clear with the attached FM indoor antenna, the use of an outdoor antenna is recommended. Connecting the AM loop antenna: The AM loop antenna is for indoor use only. Set it in the direction and position where you receive the clearest sound. Put it as far away as possible from the TX-SR701/701E/601/601E, televisions, speaker cables, and power cords. If the reception is not very clear with the attached AM indoor antenna, the use of an outdoor antenna is recommended. Insert into the hole (Indoor) AM loop antenna Other models FM antenna Connecting the AM antenna cable 1. Press down the lever at the antenna terminal. 2. Insert the wire into the terminal hole. 3. Release the lever. 1 2 3 ANTENNA AM USA and Canadian models FM 75 ZONE 2 LINE OUT L Hint: Either of the split ends of the AM antenna can be connected to either terminal. Unlike speaker cabling, there is no polarity for AM broadcast signals. 29