Onkyo TX-SR701 Owner Manual - Page 7

Supplied accessories Check that the following accessories are supplied with the TX-SR701/701E/ 601/601E. The following accessories may be available depending on the area which it was purchased. AM loop antenna × 1 FM indoor antenna × 1 Front Left Front Left SP-B / Zone 2 Left SP-B / Zone 2 Left Front Right Front Right SP-B / Zone 2 Right SP-B / Zone 2 Right Surround Left Surround Left Surround Right Surround Right Center Center Surround Back Left Surround Back Left Zone 2 Left Zone 2 Left Surround Back Right Surround Back Right Zone 2 Right Zone 2 Right Front Left Front Left SP-B / Zone 2 Left SP-B / Zone 2 Left Front Right Front Right SP-B / Zone 2 Right SP-B / Zone 2 Right Surround Left Surround Left Surround Right Surround Right Center Center Surround Back Left Surround Back Left Zone 2 Left Zone 2 Left Surround Back Right Surround Back Right Zone 2 Right Zone 2 Right Remote controller × 1 TX-SR701/701E: RC-533M TX-SR601/601E: RC-515M Batteries (AA, R6) × 2 1 2 3 Speaker Cable Speaker cable label × 1 Before using this unit Conversion plug × 1 (Use this plug if the power cord plug of the TXSR701/701E/601/601E does not fit your AC outlet. Shape may vary depending on the area which it was purchased.) 75/300 Ω antenna adapter × 1 Setting the voltage selector (Worldwide models only) Worldwide models are equipped with a voltage selector so that you can set your TX-SR701/701E/601/601E to conform with local power supplies. Be sure to set this switch to match the voltage of the power supply in your area before plugging in the unit. Determine the proper voltage for your area: 220-230 V or 120 V. If the preset voltage is not correct for your area, insert a screwdriver into the groove in the switch and slide the switch all the way to the top (120 V) or bottom (220-230 V), whichever is appropriate. ANTENNA AM COMPONENT VIDEO INPUT 2 INPUT 1 OUTPUT Y PB FM 75 ZONE 2 LINE OUT L ZONE 2 SPEAKERS L CAUTION: SPEAKER IMPEDANCE 6 OHMS MIN. /SPEAKER FRONT SPEAKERS SURROUND SPEAKERS L CENTER SPEAKER AC OUTLETS PR DIGITAL IN OUT OPTICAL 2 1 OPTICAL COAXIAL VIDEO 3 IN VIDEO 2 OUT IN IN GND L IN COAXIAL IN OUT IN IN OUT IN R VIDEO 1 OUT IN DVD IN REMOTE R CONTROL MONITOR OUT V ZONE 2 12 V TRIGGER OUT R ZONE 2 FRONT S IR IN L AV RECEIVER MODEL NO. TX-SR 701 PRE OUT R OUT IN FRONT SURR CENTER L 120 V SURR SURROUND CENTER SURR BACK BACK (SB) SPEAKER L R SUB WOOFER SWITCHED TOTAL 100W MAX. 120 V VOLTAGE SELECTOR 220-230 V R PHONO CD TAPE VIDEO 3 VIDEO 2 VOLTAGE VIDEO 1 R SUB WOOFER DVD SELECTOR 220-230 V Notes: • Do not mix new batteries with old batteries or different kinds of batteries. • To avoid corrosion, remove the batteries if the remote controller will not be used for a long time. • Remove dead batteries immediately to avoid damage from corrosion. If the remote controller does not operate smoothly, remove the old batteries and replace them both with two new AA batteries. Using the remote controller Point the remote controller toward the remote control sensor. The STANDBY indicator lights up when the unit receives a signal from the remote controller. Remote control sensor TX-SR701/701E/601/601E STANDBY indicator Installing the remote controller batteries 1. Remove the battery compartment cover by pressing it and sliding it in the direction shown by the arrow below. 2. Insert two AA (R6) batteries into the battery compartment. Carefully follow the polarity diagram (positive (+) and negative (-) symbols) inside the battery compartment. 3. After the batteries are installed and seated correctly, replace the compartment cover. 1 2 3 30˚ 30˚ Approx. 16 feet (5 meters) SEND/LEARN indicator Notes: • Make sure that the remote control sensor is not subject to strong light such as direct sunlight or inverted fluorescent light for it may prevent proper operation of the remote controller. • Using another remote controller in the same room or using the TX-SR701/701E/601/601E near equipment that uses infrared rays may cause operational interference. • Do not put objects on the remote controller. Its buttons may be pressed by mistake and drain the batteries. • Make sure the audio rack doors do not have colored glass. Placing the TX-SR701/701E/601/601E behind such doors may prevent proper remote controller operation. • If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate. 7