Optoma TX780 User Manual - Page 43

Replacing the Lamp - replacement bulb

Get Optoma TX780 PDF manuals and user guides
UPC - 796435116354
View all Optoma TX780 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 43 highlights

Appendices Replacing the Lamp The projector keeps track of the lamp usage. It will show you a warning message: Warning: Lamp compartment is hot! Allow 30 minutes to cool down before changing lamp! When you see this message, change the lamp as soon as possible. Make sure the projector has cooled down for at least 30 minutes before changing the lamp. 1 2 4 3 Warning: To reduce the risk of personal injury, do not drop the lamp module or touch the lamp bulb. The bulb may shatter and cause injury if it is dropped. Lamp Replacement Procedure: 1. Turn off the power by pressing the Power/Standby button. 2. Allow the projector to cool down for at least 30 minutes. 3. Disconnect the power cord. 4. Push up and remove the cover. 5. Use a screwdriver to remove the 3 screws from the lamp module. 6. Pull out the lamp module. To replace the lamp module, reverse the previous steps. 41 English

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
English
²±
Appendices
Replacing the Lamp
The projector keeps track of the lamp usage.
It will show you a
warning message:
When you see this message, change the lamp as soon as pos-
sible. Make sure the projector has cooled down for at least 30
minutes before changing the lamp.
Warning: Lamp
compartment is hot!
Allow 30 minutes
to cool down before
changing lamp!
Warning: To
reduce the risk of
personal injury, do not
drop the lamp module
or touch the lamp bulb.
The bulb may shatter
and cause injury if it is
dropped.
Lamp Replacement Procedure:
1.
Turn off the power by pressing the Power/Standby button.
2.
Allow the projector to cool down for at least 30 minutes.
3.
Disconnect the power cord.
4.
Push up and remove the cover.
5.
Use a screwdriver to remove the 3 screws from the lamp
module.
6.
Pull out the lamp module.
To replace the lamp module, reverse the previous steps.
2
3
1
4