Panasonic AG-DVC7 Dv Camcorder - Page 38

VCR Mode Audio Dubbing You can add music or narration to the recorded Cassette. OIf the tape recorded in the [16bit] Mode is dubbed with the Audio Dubbing function, the original sound is erased. (If you wish to preserve the original sound, use the [12bit] Mode when recording.) OAudio Dubbing cannot be performed on a recording done in LP Mode. (-18-) 1 Set [VCR FUNCTIONS] >> [AV IN/OUT SETUP] >> [AV JACK] >> [IN/OUT]. W.B/SHUTTER/IRIS > VOL/JOG MENU B PUSH 2 Continuing the aforesaid setup, select [A.DUB INPUT] >> [MIC] or [AV IN]. OSet to [AV IN] when external device is used, and to [MIC] when an external or built-in microphone is used. 3 Switch the Camera Recorder over to the Still Playback Mode where you want to add new sound. 4 Press the [A.DUB] Button i on the Remote Controller. MULTI/ P-IN-P REC A.DUB C/REW PLAY FF/ B - VOL + i STILL ADV PAUSE STILL ADV INDEX STOP INDEX u 5 To start Audio Dubbing, press the [;] Button u on the Remote Controller. To Cancel Audio Dubbing Press the [;] Button u on the Remote Controller. The Camera Recorder is in the Still Playback Mode again. To dub audio while listening to a pre-recorded sound When pausing the audio dubbing, [12bit AUDIO] on the [PLAYBACK FUNCTIONS] Sub-Menu is automatically set to [ST2] and you can check the prerecorded sound. When a microphone is used for audio dubbing, use headphones to listen to the pre-recorded sound while dubbing the audio. (When using headphones, set [AV JACK] on the [AV IN/OUT SETUP] Sub-Menu to [OUT].) When the line input is used, you can dub audio while listening to a prerecorded sound from the speaker. To Play Back the Sound Recorded by 12bit Audio Dubbing Set [VCR FUNCTIONS] >> [PLAYBACK FUNCTIONS] >> [12bit AUDIO] >> [ST2] or [MIX]. ST1: It plays back only the original sound. ST2: It plays back only the sound added by Audio Dubbing. MIX: It plays back both the original sound and the sound added by Audio Dubbing simultaneously. OFor other notes concerning this item, see -45-. $ To Adjust the Audio Level You can adjust the Audio Level for Audio Dubbing. 1 Set [VCR FUNCTIONS] >> [RECORDING SETUP] >> [AUDIO LEVEL] >> [YES]. W.B/SHUTTER/IRIS > VOL/JOG MENU B PUSH OThe [AUDIO LEVEL SETUP] Menu appears. 2 Press the [PUSH] Dial > to select the [MNL (AGC, NO-AGC)]. OThe Audio Level Meter appears. AUDIO LEVEL SETUP MODE AUTO MNL MNLŁ (AGC)(NO-AGC) (dB) -30 0 +6Ł GAIN PUSH MENU TO RETURN 3 Turn the [PUSH] Dial > to increase or decrease the bars of the [GAIN] Indication. PUSH W.B/SHUTTER/IRIS > VOL/JOG OFor details, refer to the [MIC LEVEL ADJ.] on the [RECORDING SETUP] Sub-Menu of the [CAMERA FUNCTIONS] Main-Menu (-31-). 38