Panasonic BL-MS103PK User Guide - Page 155
Wireless
View all Panasonic BL-MS103PK manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
16 Troubleshooting the BL-WV10A Issue When 2 BL-WV10A units are connected, the IP addresses are the same. 16.7 Wireless Issue The image from cameras for which Quick Setup was performed is not visible. Cannot connect to wireless camera, connection is unstable. Causes and Solutions When using Quick Setup for more than one BLWV10A, the same IP address will be used for each. • Change the IP addresses to avoid duplication on the network. Causes and Solutions When you stand in front of the camera (less than 1 m [39.4 in.] in front of the camera), does the PRIVACY button turn green? If not: • Change the camera's switch from wired to wireless. If it is already set to wireless, re-register the camera using Quick Setup. If so: • Check the wireless signal strength. Refer to the wireless communication information on page 6 and move the camera to a better position. Other wireless devices are interfering with the camera's wireless signal. • Move the wireless LAN device further away from the BL-WV10A and camera. Another wireless LAN device is using the same channel as the BL-WV10A and wireless camera. • Change the wireless channel used by the BLWV10A. Obstacles between the BL-WV10A and the camera are interfering with the wireless signal. • Refer to the wireless communication information on page 6 and clear the signal path of any obstacles, or move the BL-WV10A and camera closer. • Connect the camera using a wired connection if convenient. 154