Panasonic CQ-VX2200 Operating Instructions - Page 28
Connect All Leads, Final Installation, Final Checks
View all Panasonic CQ-VX2200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
E N Installation Guide (continued) G L I S ❏ Connect All Leads Antenna H Now that you have identified all the wires in the car, 25 you're ready to begin connecting them to the stereo Connect the antenna by plugging the antenna lead into the antenna receptacle. unit wires. The connection diagram (a Page 36 to 38) shows the proper connections and color coding of the leads. We strongly recommend that you test the unit before making a final installation. You can set the unit on the floor and make temporary connections to test the unit. Use electrical tape to cover all exposed wires. Equipment Connect any optional equipment such as an amplifier, according to the instructions furnished with the equipment. Leave about 30 cm of distance between the speaker cords/amplifier unit and the antenna/ antenna extension cord. Read the operating and installation instructions of any equipment you will connect to this unit. Important: Connect the red power lead last, after you have made and insulated all other connections. Ground Connect the black ground lead of the power connector to the metal car chassis. Speakers Connect the speaker wires. See the wiring diagram below for the proper hookups. Follow the diagram carefully to avoid damaging the speakers and the stereo unit. The speaker used must be able to handle more than 41 W of audio power. If using an optional audio power, the speakers should be able to handle the maximum amplifier output power. Speakers with low input ratings can be damaged. Speaker impedance should measure 4 - 8 Ω, which is typically marked on most speakers. Lower or higher impedance speakers will affect output and can cause both speaker and stereo unit damage. Power Connect the red power lead to the correct car radio wire or to the appropriate fuse port on the fuse block. If the stereo unit functions properly with all these connections made, disconnect the wires and proceed to the final installation. Illumination 1.Connect to light switch, the control button are illu- minated. 2.Can not find the light switch, connect the illumina- tion lead (orange with white stripe) to accessory (ACC). ❏ Final Installation Lead Connections Connect all wires, making sure that each connection is insulated and secure. Bundle all loose wires and fasten them with tape so they won't fall down later. CAUTION : Never ground the speaker cords. For example, do not use a chassis ground system or a three-wire speaker common system. Each speaker must be connected separately using parallel insulated wires. If in doubt about how your car's speakers are wired, please consult with your nearest professional installer. Motor Antenna Connect the car motor antenna lead to the blue motor antenna relay control lead. Battery Connect the yellow battery lead to the correct radio wire or to the battery fuse port on the fuse block. Congratulations! After making a few final checks, you're ready to enjoy your new auto stereo system. Connect the power cord after completion of other connections to prevent shortings. ❏ Final Checks 1. Make sure that all wires are properly connected and insulated. 2. Turn on the ignition to check the unit for proper operation. If you have difficulties, consult your nearest authorized professional installer for assistance. 34 CQ-VX2200W