Panasonic CQC1300U CQC1300U User Guide - Page 17
Final Installation, Final Checks, Connect All Leads, continued, Identify All Leads, Equipment, Power - cq c1300u radio
View all Panasonic CQC1300U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
E N G Installation Guide (continued) L I S H Identify All Leads Battery Lead If your stereo unit has a yellow lead, you will need 27 The first step in installation is to identify all the to locate the car's battery lead. Otherwise you may car wires you'll use when hooking up your sound ignore this procedure. (The yellow battery lead system. provides continuous power to maintain a clock, As you identify each wire, we suggest that you label memory storage, or other function.) it using masking tape and a permanent marker. This will help avoid confusion when making connections If your car has a radio or is pre-wired for one: later. With the ignition and headlights off, identify the car battery lead by grounding one lead of the test bulb Note: to the chassis and checking the remaining exposed ≥ Do not connect the power connector to the stereo wires from the cut radio connector plug. unit until you have made all connections. If there are no plastic caps on the stereo hooking wires, If your car is not wired for an audio unit: insulate all exposed leads with electrical tape until Go to the fuse block and find the fuse port for the you are ready to use them. Identify the leads in battery, usually marked BAT. the following order. Speakers Power Lead If your car has a radio or is pre-wired for one: Cut the connector wires one at a time from the plug (leaving the leads as long as possible) so that you can work with individual leads. Turn the ignition on to the accessory position, and ground one lead of the test bulb to the chassis. Identify the car speaker leads. There are two leads for each speaker which are usually color coded. A handy way to identify the speaker leads and the speaker they are connected with is to test the leads using a 1.5 V AA battery as follows. Hold one lead against one pole of the battery and stroke the other lead across the other pole. You will hear a scraping sound in one of the speakers if you are holding a speaker lead. If not, keep testing different lead combinations until you have located all the speaker leads. When you Touch the other lead of the test bulb to each of the label them, include the speaker location for each. exposed wires from the cut radio connector plug. Touch one wire at a time until you find the outlet that causes the test bulb to light. Antenna Motor If your car is equipped with an automatic power antenna, identify the car motor antenna lead by Now turn the ignition off and then on. If the bulb also turns off and on, that outlet is the car power lead. If your car is not wired for an audio unit: Go to the fuse block and find the fuse port for radio (RADIO), accessory (ACC), or ignition (IGN). connecting one bulb tester lead to the car battery lead and touching the remaining exposed wires from the cut radio connector plug one at a time. You will hear the antenna motor activate when you touch the correct wire. Antenna The antenna lead is a thick, black wire with a metal plug at the end. 40 CQ-C1300U Connect All Leads Now that you have identified all the wires in the car, you are ready to begin connecting them to the stereo unit wires. The wiring diagram (page 44) shows the proper connections and color coding of the leads. We strongly recommend that you test the unit before making a final installation. You can set the unit on the floor and make temporary connections to test the unit. Use electrical tape to cover all exposed wires. Important: ≥ Connect the red power lead last, after you have made and insulated all other connections. Ground Connect the black ground lead of the power connector to the metal car chassis. Speakers Connect the speaker wires. See the wiring diagram (page 44) for the proper hookups. Follow the diagram carefully to avoid damaging the speakers and the stereo unit. The speakers used must be able to handle more than 50 W of audio power. If using an optional audio amplifier, the speakers should be able to handle the maximum amplifier output power. Speakers with low input ratings can be damaged. Speaker impedance should measure 4-8 ≠, which is typically marked on most speakers. Lower or higher impedance speakers will affect output and can cause both speaker and stereo unit damage. Motor Antenna Connect the car motor antenna lead to the dark blue motor antenna relay control lead. (Do not confuse the antenna lead with blue/white stripe lead for a power amplifier.) Battery Connect the yellow battery lead to the correct radio wire or to the battery fuse port on the fuse block. Antenna Connect the antenna by plugging the antenna lead into the antenna receptacle. E N G L I Equipment S H Connect any optional equipment such as an amplifier, according to the instructions furnished 28 with the equipment. Leave about 12q (30 cm) of distance between the speaker leads/amplifier unit and the antenna/antenna extension cord. Read the operating and installation instructions of any equipment you will connect to this unit. Power Connect the red power lead to the correct car radio wire or to the appropriate fuse port on the fuse block. If the stereo unit functions properly with all these connections made, disconnect the wires and proceed to the final installation. Final Installation Lead Connections Connect all wires, making sure that each connection is insulated and secure. Bundle all loose wires and fasten them with tape so they will not fall down later. Now insert the stereo unit into the mounting collar. Congratulations! After making a few final checks, you're ready to enjoy your new auto stereo system. Final Checks 1. Make sure that all wires are properly connected and insulated. 2. Make sure that the stereo unit is securely held in the mounting collar. 3. Turn on the ignition to check the unit for proper operation. If you have difficulties, consult your nearest authorized professional installer for assistance. CQ-C1300U 41