Panasonic CQC5305U CQC5305U User Guide - Page 7

General  Up  Down Setting Range: 0 to 40 Default: 18 Note: The volume level can be set independently for each source. (For radio, one volume setting for AM, one volume setting for all FMs) Volume Adjustment (VOLUME) Temporary Volume Off (Down) MUTE (ATT: Attenuation) Volume Off (down) Press [MUTE]. Cancel Press [MUTE] again. Note: You can select mute or attenuation. ( page 23) Caution • Set the volume level to low enough before the AUX connection is completed. Failure to observe this, the loud noise may come out and damage your speakers and your hearing. The source changes as follows every time [SOURCE] is pressed. AUX1 (AUX1 in) (3.5 mm  stereo) From line output of external sound/audio device (ex. Silicon-audio player, HDD player, etc.) Radio FM1, FM2, FM3, AM ( page 14) System-up Connector When an optional device is connected: Shift to connected device When connecting CD changer Player When loading CD ( page 16) When loading MP3/WMA/AAC disc ( page 18) When connecting iPod When connecting XM Receiver When connecting Sirius Receiver Source Selection (SOURCE) AUX1 Device connected to the AUX1 terminal of this unit OR When an expansion module is connected: The devices connected to the ports 1 to 4 are activated in sequence after shifting to AUX2 (device connected to the AUX terminal of the expansion module). Note: For information about connectable devices, refer to the System Upgrade Guidebook or the instruction manual for each device. 12 CQ-C5405U/C5305U Sound Control SQ Selection Based on Genre SQ (Sound Quality) You have 6 preset modes (FLAT, ROCK, POP, VOCAL, JAZZ, CLUB). You can customize your settings for these and save them for instant recall. SQ Changeover Press [SQ] to activate the SQ selection mode. Press [SQ] to select the sound type as follows. Press [DISP] to return to the regular mode. Notes: • After pressing [SQ] on the main unit, you can also select a sound type by pressing the preset buttons [1] to [6]. • Please refer to page 22 for the adjustment to each speaker and an optional subwoofer. · Bass adjustment · Treble adjustment · Balance adjustment · Fader adjustment · Subwoofer level adjustment · Subwoofer low pass filter · Re-master setting (FLAT) flat frequency response: does not emphasize any part. (Default) (ROCK) speedy and heavy sound: exaggerates bass and treble. (POP) wide-ranged and deep sound: slightly emphasizes bass and treble. (VOCAL) clear sound: emphasizes middle tone and slightly emphasizes treble. (JAZZ) jazz-specific deep sound: sound with emphasis on sharpness of highhat and echo saxophone. (CLUB) club and disco-specific sound: reproduction of realism being in a club. You can adjust the characteristics of the currently selected sound type (SQ). ( above) It is also possible to preset up to 5 different adjusted SQs. SQ3 (3-Band Sound Quality) Center frequency and level are adjustable in each of 3 bands. This lets you fine-tune sound quality for each genre to suit car-interior acoustics and your personal preferences. Tone/SQ adjustable range: 12 dB to 12 dB (by 2 dB) SQ Low/Bass: ±12 dB (at 60 Hz, 80 Hz, 100 Hz, 200 Hz) SQ Mid: ±12 dB (at 500 Hz, 1 kHz, 2 kHz, 3 kHz) SQ High/Treble: ±12 dB (at 8 kHz, 10 kHz, 12 kHz, 15 kHz) • The bass/treble control level of each frequency is fixed to the frequency that has been selected for SQ. To return an adjusted SQ to the default setting Press [SQ], and select the SQ which is to be returned to the default setting. (Only for main unit) Hold down [BAND] for 2 sec. or more. 1 Press [VOL] (PUSH SEL: Select) to open the menu. 2 Press [VOL] (PUSH SEL: Select) to select a mode to be adjusted. 3 Adjust each band. /: center frequency up/down Band selection Level up/down Band Level Frequency 4 Hold down the numeric button [2] to [6] for 2 sec. or more. • The adjusted SQ is preset in the number of the selected button, and return to the regular mode resumes. • When you suspend the SQ preset adjustment, each level remains your recent adjustment until a new SQ presetting operation is performed or you call up the SQ preset. Notes: • You cannot save any SQ presetting value in [1] button. • Any SQ adjustments will not change the call up screen names such as ROCK and JAZZ. • Do not activate SQ and Bass/Treble at the same time to avoid causing sound distortion. CQ-C5405U/C5305U 13 SQ Adjustment General, Sound Control English