Panasonic DMPBBT01 DMPBBT01 User Guide - Page 34

Indicator Reference illumination Confirm the following items in correspondence to the status of the LED of the unit. An error condition exists when the Status LED is red. Open the panel at the side of the main unit and check the status of the indicator LEDs. If the red LED does not turn off even when following operation is performed, contact your dealer. Indicator LEDs Red flashes for 6 times The red or green light flashes slowly Description The remote control and main unit are using different codes. Remote control code may be changed when the battery is changed. Reset the settings of the main unit and the remote control to the states at the time of purchase with following operation. 1 Turn the unit off once, and then turn it on again. 2 Touch and hold [ 33, "Remote Control Code") The unit is carrying out an internal process. This is not a malfunction. You cannot operate the unit while the light is flashing. Wait for a while. Red lights up Red lights up Red lights up 34 VQT3W08 Lights up Flashes The unit fails to operate properly. Touch and hold [Í/I] on the main unit for 3 seconds to switch the unit to standby, then switch back on. Lights up Flashes The USB device is drawing too much power. Please disconnect or remove the USB device from the unit. The USB device may be incompatible. Lights up The unit is hot. If the maximum operating temperature is exceeded the unit automatically switches to standby. In this case turn the unit off for approximately 30 minutes and make sure that there is adequate air flow around the unit.