Panasonic HL-CX667 Operating / Installing Instructions - Page 21

English Troubleshooting Problem Possible Causes and Solution The oven display stays OFF. Turn off the power, and 1 minute later, turn on the power. If the condition persists, contact a qualified technician or an authorized service center. Keys react even when Clean the key surface and make sure the button surface is dry. only their vicinity is If the condition persists, contact a qualified technician or an touched. authorized service center. Cooling fan continues The cooling system comes into operation as soon as a cooking to run after oven is function starts. It will continue to work for 15 minutes or until turned off. the temperature of oven becomes below 160 °F (70 °C) after cooking is finished. Oven is not heating. (1) When using the reminder function, oven will turn on automatically at preset time. Press twice to cancel the function. (2) Check the circuit breaker or fuse box to your house. (3) Make sure there is proper electrical power to the oven. (4) Make sure the oven temperature has been selected. (5) Make sure the oven function has been selected. Oven is not cooking evenly. (1) Verify food is not in the oven during preheating. (2) Verify the cooking mode. (3) Refer to the operating instructions for tips on the best rack position to use. (4) Check that the appropriate temperature is set for the recipe. Oven temperature is too hot or too cold. (1) Check that the appropriate temperature is set for the recipe. (2) The heating elements are not working. If condition persists, contact a qualified technician or an authorized service center. Oven lamp is not working properly. Replace or reinsert the lamp bulb if loose or defective. Touching the bulb with fingers may cause the bulb to burn out. Clock and the Make sure there is proper electrical power to the oven. See reminder function are Clock Setting (p. 9) and Reminder Function (p. 11). not working properly. Excessive moisture is When cooking is finished, open the door slowly staying from the in the oven. oven as far as possible to prevent the body from being burned by steam. Enamel coating of the oven cavity has removed. When oven racks are removed and replaced, always tilt them upward and do not force them to prevent the enamel from chipping. Even if a small area of the cavity enamel has removed, it does not affect using. However, the soonest replacement is recommended to prevent the metal under the enamel coating from rusting. The oven is not turned Check the circuit breaker and the fuse, and reset the circuit on. breaker or replace the fuse if it is tripped or blown. If the condition persists, contact a qualified technician or an authorized service center. The oven lamp is dimming. (1) This may be caused by the voltage instability when the higher power level is used for cooking. It does not indicate a problem with your oven. (2) Wipe and clean the covering glass of the lamp to get the maximum brightness. EN-19