Panasonic HL-CX667 Operating / Installing Instructions - Page 25
Wiring Connections
View all Panasonic HL-CX667 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
English CAUTION Do not repair or replace any part of the appliance unless specifically recommended in the manual. All other servicing should be done by a qualified technician. This may reduce the risk of personal injury and damage to the oven. Never modify or alter the construction of the appliance by removing panels, wire covers, screws, or any other part of the appliance. Wiring Connections Be sure your appliance is properly installed and grounded by a qualified technician. Ask your dealer to recommend a qualified technician or an authorized repair service. This appliance is manufactured with a green GROUND wire connected to the oven chassis. After making sure that the power has been turned off, connect the flexible conduit from the oven to the junction box using a U.L. listed conduit connector. Figures 1 and 2 and the instructions provided below present the most common way of connecting the ovens. Your local codes and ordinances, of course, take precedence over these instructions. Complete electrical connections according to local codes and ordinances "WARNING" Risk of Electric Shock, frame grounded to neutral of appliance through a link. Grounding through the neutral conductor is prohibited for new branch-circuit installations (1996 NEC); mobile homes; and recreational vehicles, or in an area where local codes prohibit grounding through the neutral conductor. For installations where grounding through the neutral conductor is prohibited: • Disconnect the ground from the neutral at free end of conduit; • Use grounding terminal or lead to ground unit; and • Connect neutral terminal or lead to branch circuit neutral in usual manner. ■■3-Wire Branch Circuit Refer to Figure 1, where local codes allow the connection of GROUND wire from the oven to the branch circuit NEUTRAL wire (gray or white colored wire): • If local codes permit, connect the green GROUND wire from the oven and the white wire from the oven to the branch circuit NEUTRAL wire (gray or white colored wire). • Connect the red and black leads from the oven to the corresponding HOT Wires in the junction box. • Connect the local codes and power supply codes using a terminal. • The terminal uses a thing adapting to the wire of the cord. Grounded Neutral Junction box Cable from power supply Red wires White wires Bare or green wire Black wires Cable from oven U.L.-listed conduit connector Figure 1 EN-23