Panasonic HX-A1M Owners Manual - Page 51
About the microSD card, About firmware updates, Initializing the network settings, About the battery
View all Panasonic HX-A1M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 51 highlights
About the microSD card ≥ The memory capacity listed on the microSD card label is the total of the capacity that is used for protection and management of copyright, and capacity that can be used normally with this unit and computer. ≥ Do not subject the microSD card to strong shocks, bend it or drop it. ≥ Data on the microSD card may be damaged or deleted due to electrical noise, static electricity or malfunctions with this unit or the microSD card. When the microSD card is being accessed (when the access lamp is lit or flashing), do not perform the following: j Remove the microSD card j Turn the unit off j Insert and remove the USB cable j Expose the unit to vibrations or shock 2 Copy the update file to the microSD card and insert it into this unit. 3 While pressing and holding the recording mode/Wi-Fi button (l 9) and the recording start/stop button (l 9), press and hold the power button. 4 When the power lamp and access lamp start flashing red, remove your finger from the buttons. ≥ The firmware update will start. 5 When the access lamp lights (while the power lamp is flashing), turn off this unit. 6 Turn on this unit. For the latest update information, check the support website below. (As of May 2015) http://panasonic.jp/support/global/cs/e_cam/ index.html (This site is English only.) When disposing of or giving away the microSD card, note that: ≥ Formatting and deletion of data on this unit or computer only changes the file management information and does not completely delete the data in the microSD card. ≥ It is recommended that the microSD card is physically destroyed when disposing of the microSD card. ≥ The customer is responsible for the management of the data in the microSD card. Cautions for using a microSD card ≥ Do not expose the terminals of the microSD card to water, dirt or dust. ≥ Do not place microSD cards in the following areas: j In direct sunlight j In very dusty or humid areas j Near a heater j Locations susceptible to significant difference in temperature (condensation can occur.) j Where static electricity or electromagnetic waves occur ≥ To protect microSD cards, return them to their cases when you are not using them. About firmware updates To update the firmware version of this unit, follow the steps below. 1 Turn off this unit. Initializing the network settings To reset the network settings to the default, after turning off this unit, press the power button (l 9) and recording start/stop button (l 9) simultaneously to turn it on again and continue to hold them down for approximately 3 seconds. When the Wi-Fi lamp flashes alternately in red and green, the network settings are initialized. ≥ After initializing the settings, turn off and on this unit. ≥ The following settings will be reset to the default: j An SSID/password for this unit set after the purchase ([Camera Wi-Fi settings] # [Camera SSID settings] in the "Image App") j SSID/Password of Main Camera that was connected to this unit (l 37) About the battery The battery used in this unit is a rechargeable lithium-ion battery. It is susceptible to humidity and temperature and the effect increases the more the temperature rises or falls. Due to the waterproof, dustproof, and antishock design of this product, it is not possible to replace the built-in battery. If the operating time is very short even after the battery has been recharged, the battery has worn out. - 51 -