Panasonic KX-HN1032W Operating Instructions - Page 12

Getting Started Connections Insert the AC adaptor plug firmly into the DC jack. Connect the AC adaptor to the power outlet. Note: R Use only the supplied AC adaptor S006AKU0500100. 2 1 Note about power connections AC adaptor connection R The AC adaptor must remain connected at all times. (It is normal for the adaptor to feel warm during use.) R The AC adaptor should be connected to a vertically oriented or floor-mounted AC outlet. Do not connect the AC adaptor to a ceiling-mounted AC outlet, as the weight of the adaptor may cause it to become disconnected. Power failure R The camera unit will not work during a power failure. Placing the camera unit on a flat surface The camera unit can be placed on a flat surface, however make sure to choose a stable location. Wall mounting R Attach the wall mounting adaptor to the camera unit after making the connections (page 12). R Only use the supplied screw that is attached to the camera base when attaching the wall mounting adaptor to the camera unit. Do not use user supplied screws. This may cause the camera unit to become loose from the wall mounting adaptor. R Mount the camera unit on the stable location where the unit can be adequately supported when installing. R Use a string or wire to prevent the camera unit from falling and causing injury if the camera unit comes off from the wall. R Do not mount the wall mounting adaptor to a ceiling. R Do not mount the camera unit on a soft material. It may fall down, break or cause injury. R Do not mount the camera unit on the following places: plaster board, ALC (autoclaved lightweight cellular concrete), concrete block, plywood less than 25 mm (1 inch) thick, etc. 1 Remove the screw and then remove the camera base from the camera unit. 1 1 Supplied screw (page 9) 2 Attach the wall mounting adaptor to the camera unit. 12 For assistance, please visit http://shop.panasonic.com/support HN4001_(en_en)_0517_ver.020.pdf 12 2019/05/17 13:52:59