Panasonic KX-HN1032W Operating Instructions - Page 35

Appendix FCC and other information This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Privacy of communications may not be ensured when using this device. CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device. a TV or VCR. If interference is experienced, move this device further away from the TV or VCR. This will often reduce or eliminate interference. FCC RF Exposure Warning: R This product complies with FCC radiation exposure limits set forth for an uncontrolled environment. R To comply with FCC RF exposure requirements, the device must be installed and operated 20 cm (8 inches) or more between the product and all person's body. R This product may not be collocated or operated in conjunction with any other antenna or transmitter. Notice: R FCC ID can be found on the rear of the unit. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/ TV technician for help. Charge only mode The charge only mode is the dedicated mode to charge the battery of the baby monitor. Do not use this mode if it is unnecessary because all functions except the baby monitor's battery charge are disabled with this mode. n To activate the charge only mode: 1 Press M N (power) for about 2 seconds until the baby monitor shuts down. 2 Connect the charger to the baby monitor. After the LED indicator on the top of the baby monitor illuminates in amber color for about 30 seconds, the LED indicator turns off automatically. Then the baby monitor goes into charge-only mode. n To deactivate the charge only mode: - Press M N (power) for about 2 seconds until the LCD display of the baby monitor illuminates. Some devices operate at frequencies that may cause interference to nearby TVs and VCRs. To minimize or prevent such interference, this device should not be placed near or on top of For assistance, please visit http://shop.panasonic.com/support 35 HN4001_(en_en)_0517_ver.020.pdf 35 2019/05/17 13:53:00