Panasonic KX-HNC600 Installation Guide - CA - Page 16
Registering the camera, Confirming the installation area, Setup
![]() |
View all Panasonic KX-HNC600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Setup Registering the camera This procedure is not required for devices that were included as part of a bundle. Before you can use the camera, it must be registered to the hub. If the camera is not registered to a hub, the camera's LED indicator blinks slowly in amber. You can register each device by using the registration buttons or the [Home Network] app. Note: R Before registering the camera, make sure the AC adaptors of the hub and camera are connected and each device is powered. Using the app When you register the camera by using the [Home Network] app, you can assign a name to your devices and group them by location. For more information, refer to the User's Guide (page 26). Confirming the installation area Before deciding where to install the camera, carefully read the chapter "Installation Location", beginning on page 8, to confirm the installation location and direction. Using registration buttons 1 Hub: Press and hold M CAMERAN until the LED indicator blinks slowly in green. 2 Camera: Using an object with a thin tip, press and hold M N until the LED indicator blinks slowly in green (page 15). R When registration is complete, the hub sounds one long beep. Note: R To cancel without registering the camera, press M N on the hub and on the camera again. R If registration fails, the hub sounds several short beeps. 16 For assistance, visit www.panasonic.ca/english/support HNC600C_(en_en)_0113_ver.201.pdf 16 2017/01/13 11:54:13
![](/manual_guide/products/panasonic-kxhnc600-installation-guide-ca-ad03a2e/16.png)