Panasonic KX-HNS103 Operating Instructions CA - Page 12
Installation location
View all Panasonic KX-HNS103 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Setup R Touching the metal probes with your hand may cause a water leak to be detected. This is not a defect. R Install the probe unit so that the metal probes are horizontal. A water leak can only be detected if water touches both of the metal probes; if water touches only one of the probes, a water leak will not be detected. Correct installation Incorrect installation Metal probes are horizontal to the floor Metal probes are not horizontal to the floor Installation location Install the water leak sensor in a basement, kitchen, utility room, or anywhere you want to detect a water leak. Common installation examples include near a washing machine, hot water heater, or a location where a water leak has occurred in the past. Note: R Install the probe unit so that its metal probes are about 1 mm (1/32 inches) above the floor. If the probes touch the floor, the sensor may make false detections. If the probes are too far from the floor, water leaks can only be detected after the leaked water has become deep enough to touch the probes. 12 For assistance, visit www.panasonic.ca/english/support HNS103C_(en-en)_0224_ver.020.pdf 12 2015/02/24 15:14:55