Panasonic KX-TG2711 Operating Instructions CA - Page 31

Error messages, Troubleshooting, Useful Information

Get Panasonic KX-TG2711 PDF manuals and user guides View all Panasonic KX-TG2711 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

Useful Information Error messages Display message Busy Error!! No link to base. Reconnect main base AC adaptor. Cause/solution R The called unit is in use. R Other units are in use and the system is busy. Try again later. R The handset you are using is too far from the base unit. Move closer and try again. R There is no handset registered to the base unit matching the handset number you entered. R Recording was too short. Try again. R The handset has lost communication with the base unit. Move closer to the base unit and try again. R Unplug the base unit's AC adaptor to reset the unit. Reconnect the adaptor and try again. R The handset's registration may have been cancelled. Re-register the handset (page 34). Troubleshooting If you still have difficulties after following the instructions in this section, disconnect the base unit's AC adaptor, then reconnect the base unit's AC adaptor. Remove the batteries from the handset, and then insert the batteries into the handset again. General use Problem The handset does not turn on even after installing charged batteries. The unit does not work. Cause/solution R Place the handset on the base unit or charger to turn on the handset. R Make sure the batteries are installed correctly (page 9). R Fully charge the batteries (page 9). R Check the connections (page 9). R Unplug the base unit's AC adaptor to reset the unit. Reconnect the adaptor and try again. R The handset has not been registered to the base unit. Register the handset (page 34). 31

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
Error messages
Display message
Cause/solution
Busy
R
The called unit is in use.
R
Other units are in use and the system is busy. Try
again later.
R
The handset you are using is too far from the base
unit. Move closer and try again.
R
There is no handset registered to the base unit
matching the handset number you entered.
Error!!
R
Recording was too short. Try again.
No link to base. Reconnect
main base AC adaptor.
R
The handset has lost communication with the base
unit. Move closer to the base unit and try again.
R
Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R
The handset’s registration may have been cancelled.
Re-register the handset (page 34).
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s
AC adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset,
and then insert the batteries into the handset again.
General use
Problem
Cause/solution
The handset does not turn on
even after installing charged
batteries.
R
Place the handset on the base unit or charger to turn on
the handset.
The unit does not work.
R
Make sure the batteries are installed correctly (page 9).
R
Fully charge the batteries (page 9).
R
Check the connections (page 9).
R
Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R
The handset has not been registered to the base unit.
Register the handset (page 34).
31
Useful Information