Panasonic KX-TGA273S C-r H-s For Kxtg2700 - Page 6

THINGS YOU SHOULD KNOW, CAUTION, for Charger Unit - handset

Page 6 highlights

5 Things You Should Know Things You Should Know 5-A Optional Headset 5-C FCC and Other Information Plugging an optional headset into the handset allows for a hands-free phone conversation. Please use only a Panasonic KX-TCA60, KX-TCA86, KX-TCA88, KX-TCA91, KX-TCA92 or KX-TCA98 headset. To order, call the accessories telephone number in section 1-A. To connect a headset Open the headset jack cover, and connect the headset to the headset jack as shown. Headset Jack H Headset sold separately. Model shown here is KX-TCA88. •To switch to the speakerphone while using the headset: Press [ ]. To return to the headset, press [ ]. 5-B Troubleshooting (for Charger Unit) Problem Cause & Remedy The clock shows " ". •The clock needs to be set (1-H). There is excessive noise from the radio. •Move the charger away from other electrical appliances. No sound from the radio. •Make sure the AC adaptor is connected and the antenna is standing (1-C). " " is displayed below the time. •A power failure may have occurred or the AC adaptor may be disconnected. Reconnect power. If the unit loses power for about 10 minutes, clock memory will be lost (1-H). Radio and buzzer alarm settings (4-A, 4-B), and radio station presets will also be lost (2-B). All preset FM stations have been erased and the radio alarm does not sound at the set time. •If you have changed the tuning step for FM (2-E), all preset FM stations and the radio alarm setting will be erased. The buzzer alarm will sound at the set time instead of the radio. The radio/buzzer alarm does not sound at the set time. •A power failure may have occurred and the alarm time may be erased. If you cannot solve your problem •For handset troubleshooting, please see the base unit Operating Instructions. •Call our customer call center at 1-800-211-PANA(7262). •Panasonic's e-mail address for customer inquiries: [email protected] for customers in the USA or Puerto Rico ONLY WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR) MAKING TEST CALLS TO EMERGENCY NUMBERS: 1)Remain on the line and briefly explain to the dispatcher the reason for the call. 2)Perform such activities in the off-peak hours, such as early morning or late evenings. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Privacy of communications may not be ensured when using this phone. CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this device. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. Operating near 2.4GHz electrical appliances may cause interference. Move away from the electrical appliances. CAUTION: To comply with FCC RF exposure requirements, the handset should be carried with the specific belt-clip provided for the handset to ensure compliance. Other non-tested belt-clips or similar bodyworn accessories may not comply, therefore, should be avoided. This equipment is hearing aid compatible as defined by the FCC in 47 CFR Section 68.316. When you hold the phone to your ear, noise might be heard in your Hearing Aid. Some Hearing Aids are not adequately shielded from external RF (radio frequency) energy. If noise occurs, use an optional headset accessory or the speakerphone option (if applicable) when using this phone. Consult with your audiologist or Hearing Aid manufacturer about the availability of Hearing Aids which provide adequate shielding to RF energy commonly emitted by digital devices. CAUTION: To reduce the risk of fire or injury to persons, read and follow these instructions. 1. Use only the battery(ies) specified. 2. Do not dispose of the battery(ies) in a fire. They may explode. Check with local waste management codes for special disposal instructions. 3. Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed. For assistance, please call: 1-800-211-PANA(7262)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9

CAUTION:
To reduce the risk of fire or injury to persons, read and follow
these instructions.
1.
Use only the battery(ies) specified.
2.
Do not dispose of the battery(ies) in a fire. They may explode.
Check with local waste management codes for special disposal
instructions.
3.
Do not open or mutilate the battery(ies). Released electrolyte is
corrosive and may cause burns or injury to the eyes or skin.
The electrolyte may be toxic if swallowed.
When you hold the phone to your ear, noise might be heard in
your Hearing Aid. Some Hearing Aids are not adequately
shielded from external RF (radio frequency) energy. If noise
occurs, use an optional headset accessory or the speakerphone
option (if applicable) when using this phone. Consult with your
audiologist or Hearing Aid manufacturer about the availability of
Hearing Aids which provide adequate shielding to RF energy
commonly emitted by digital devices.
5
Things You Should Know
Things You Should Know
5-B Troubleshooting
(for Charger Unit)
For assistance, please call: 1-800-211-PANA(7262)
5-A
Optional Headset
Plugging an optional headset into the handset allows for a hands-free
phone conversation. Please use only a Panasonic KX-TCA60,
KX-TCA86, KX-TCA88, KX-TCA91, KX-TCA92 or KX-TCA98
headset. To order, call the accessories telephone number in section
1-A.
To connect a headset
Open the headset jack cover, and connect the headset to the headset
jack as shown.
H
To switch to the speakerphone while using the headset:
Press
[
]
. To return to the headset, press
[
]
.
Headset sold separately.
Model shown here is KX-TCA88.
Headset Jack
Problem
The clock shows “
”.
There is excessive noise
from the radio.
No sound from the radio.
” is displayed below the
time.
All preset FM stations have
been erased and the radio
alarm does not sound at
the set time.
The radio/buzzer alarm
does not sound at the set
time.
If you cannot solve your
problem
Cause & Remedy
The clock needs to be set (1-H).
Move the charger away from other
electrical appliances.
Make sure the AC adaptor is
connected and the antenna is
standing (1-C).
A power failure may have occurred
or the AC adaptor may be
disconnected. Reconnect power. If
the unit loses power for about 10
minutes, clock memory will be lost
(1-H).
Radio and buzzer alarm
settings (4-A, 4-B), and radio station
presets will also be lost (2-B).
If you have changed the tuning
step for FM (2-E), all preset FM
stations and the radio alarm setting
will be erased. The buzzer alarm
will sound at the set time instead of
the radio.
A power failure may have occurred
and the alarm time may be erased.
For handset troubleshooting,
please see the base unit Operating
Instructions.
Call our customer call center at
1-800-211-PANA(7262).
Panasonic
s e-mail address for
customer inquiries:
for customers in the USA or Puerto
Rico ONLY
5-C
FCC and Other Information
WHEN PROGRAMMING EMERGENCY NUMBERS AND(OR)
MAKING TEST CALLS TO EMERGENCY NUMBERS:
1)Remain on the line and briefly explain to the dispatcher the
reason for the call.
2)Perform such activities in the off-peak hours, such as early
morning or late evenings.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.
Privacy of communications may not be ensured when using this
phone.
CAUTION:
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user
s authority to
operate this device.
Note:
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
Operating near 2.4GHz electrical appliances may cause
interference. Move away from the electrical appliances.
CAUTION:
To comply with FCC RF exposure requirements, the handset
should be carried with the specific belt-clip provided for the handset
to ensure compliance. Other non-tested belt-clips or similar body-
worn accessories may not comply, therefore, should be avoided.
This equipment is hearing aid compatible as defined by the FCC
in 47 CFR Section 68.316.