Panasonic KXTC1852B Digital Spread Spect - Page 49
Before Requesting Help
View all Panasonic KXTC1852B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Before Requesting Help " Problem "No link to base. Place on cradle and try again." is displayed and an alarm tone sounds. The unit does not work. Static, sound cuts in/out, fades. Interference from other electrical units. The handset does not ring. The handset display is blank. The handset display is still blank after pressing BACK (fi) or FWD/EDIT (fl). Remedy ≥You are too far from the base unit. Move closer and try again. ≥Place the handset on the base unit and try again. ≥Plug in the AC adaptor. ≥Raise the base unit antenna. ≥Check the settings (p. 10-15). ≥Charge the battery fully (p. 11). ≥Clean the charge contacts and charge again (p. 12). ≥Install the battery properly (p. 11, 48). ≥Place the handset on the base unit and unplug the AC adaptor to reset. Plug in, and try again. ≥Locate the handset and the base unit away from other electrical appliances (p. 3). ≥Move closer to the base unit. ≥Raise the base unit antenna. ≥Press (FUNCTION/EXIT/CH) to select a clearer channel. ≥The ringer volume is set to OFF. Set to HIGH or LOW (p. 18). ≥If the line is connected to a low voltage system such as a PBX, the unit may not ring. Set the line mode to "B" (p. 15). ≥The handset is in the standby mode (p. 12). Press BACK (fi) or FWD/EDIT (fl) to turn the display on. ≥Charge the battery fully (p. 11). Useful Information 49