Panasonic PTDW5100 User Manual - Page 35

OPTION1 settings OPTION1 COLOR MATCHING COLOR CORRECTION CONTRAST MODE AUTO SIGNAL BACK COLOR STARTUP LOGO SUB MEMORY LIST DVI EDID DVI SIGNAL LEVEL FUNC1 OSD POSITION OSD MEMORY OFF USER NORMAL OFF BLUE OFF EDID2:PC 0-255:PC 1 ON MENU SELECT CHANGE COLOR MATCHING When multiple sets are used simultaneously, this projector allows the user to correct the difference of colors among the sets. Press to select "COLOR MATCHING". Press to switch "COLOR MATCHING". The setting will change as follows each time is pressed. OFF : Color matching adjustment is not carried out. 3COLORS : It is possible to adjust the 3 colors of "R (Red)", "G (Green)" and "B (Blue)" and "Wh (White)"*. * When "3COLORS" is selected, only the brightness can be adjusted for "Wh". 7COLORS : It is possible to adjust the 7 colors of "R (Red)", "G (Green)", "B (Blue)", "Cy (Cyan)", "Mg (Magenta)", "Ye (Yellow)" and "Wh (White)". MEASURE : Refer to "Adjusting the color matching using a colorimeter" on the right for details on these modes. If "3COLORS" or "7COLORS" was selected in step 2. Press the ENTER button. The "COLOR MATCHING: 3COLORS" or "COLOR MATCHING: 7COLORS" screen will be displayed. Press "Wh". to select "R", "G", "B" and ("R", "G", "B", "Cy", "Mg", "Ye" and "Wh" when selecting "7COLORS".) Press the ENTER button. Press to adjust the values. These values can be adjusted from 0 to 2048. (If the default value of the color is 2048, the value can be adjusted from 256 to 2048.) Note • The effects of correcting the adjustment color When tuning the correction color that is the same as the adjustment color : The brightness of the adjustment color changes. When tuning the correction color RED : RED is added to or reduced from the adjustment color. When tuning the correction color GREEN : GREEN is added to or reduced from the adjustment color. When tuning the correction color BLUE : BLUE is added to or reduced from the adjustment color. • This adjustment should be carried out by a person who is familiar with the projector or by a service person because a high level of skill is required to make successful adjustment. • Pressing the DEFAULT button will restore the factory defaults for all items. • When any setting other than "OFF" has been selected for "COLOR MATCHING", "AI", "COLOR CORRECTION" and "COLOR TEMP" settings are not adjustable. • When "AUTO TESTPATTERN" is set to "ON", the test pattern for adjusting the adjustment color is automatically displayed. Adjusting the color matching using a colorimeter The "R (Red)", "G (Green)", "B (Blue)", "Cy (Cyan)", "Mg (Magenta)", "Ye (Yellow)" and "Wh (White)" colors can be changed to the desired hues using a colorimeter which is capable of measuring the chromaticity coordinates and luminance. Inputting the current luminance and chromaticity coordinates Press to select "COLOR MATCHING". Press to select "MEASURE". Press the ENTER button. The "COLOR MATCHING:MEASURE" screen will be displayed. Press to select "MEASURED DATA". Press the ENTER button. The "MEASURED DATA" screen will be displayed. Use the colorimeter to measure the luminance (Y) and chromaticity coordinates (x, y). Press press to select the colors, and to select their values. (Continued on the next page) 35