Panasonic PTDW5100 User Manual - Page 36

OPTION1 settings After all the data has been input, press the MENU button. The "COLOR MATCHING:MEASURE" screen will be displayed. Inputting the coordinates of a desired color Press to select "TARGET DATA". Press the ENTER button. The "TARGET DATA" screen will be displayed. Press to select the desired colors, and press to input their coordinates. After all the data has been input, press the MENU button. Note • If the target data is outside the color range of the projector, the colors will not be projected correctly. • When "AUTO TESTPATTERN" is set to "ON", the test pattern for adjusting the adjustment color is automatically displayed. • Set "PICTURE MODE" to "DYNAMIC" when measuring the measured data using a colorimeter or other measuring device. • Depending on the measuring device being used and the environment in which measurements are made, discrepancies sometimes occur in the color coordinates of the target data and the values given by the measuring device. COLOR CORRECTION OFF : This is the standard setting. USER : The six colors of red, green, blue, cyan, magenta and yellow can be adjusted and registered for each of four signal systems: Video, S-Video, RGB and YPBPR. Press the ENTER button to make the detailed settings. COLOR CORRECTION R G B Cy Mg Ye RGB 0 0 0 0 0 0 MENU SELECT ADJUST The current signal system is displayed. CONTRAST MODE There are two modes for adjusting to the operating environment. NORMAL : The brightness is set to maximum. HIGH : The contrast is set to maximum. 36 AUTO SIGNAL The position where the screen is displayed can be adjusted automatically without pressing the AUTO SETUP button on the remote control each time signals are input when signals are input frequently such as when the projector is used at a conference. ON : Auto setup is performed automatically when the video signals of the images being projected have changed. OFF : The input auto setup function is set to OFF. BACK COLOR You can set the colors of the screen when no signal is input to the projector. BLUE : Set screen color to blue. BLACK : Set screen color to black. LOGO1 : The picture registered by the user will be projected. LOGO2 : The Panasonic logo is projected. STARTUP LOGO This sets the startup logo that is projected when the power is turned on. LOGO2 : This is the standard setting. The Panasonic logo is projected. NONE : "STARTUP LOGO" is disabled. LOGO1 : The picture registered by the user will be projected. Note • Separate software is required in order to create the pictures to use for "LOGO1". Consult your dealer. SUB MEMORY LIST Multiple sets of image adjustment data (PICTURE, POSITION, ADVANCED MENU adjustment values) for the same kind of signal can be registered. SUB MEMORY LIST - : RGB1-XGA60 1: RGB1-XGA60 2: VIDEO-NTSC 3: 4: 5: 6: 7: 8: SELECT STORE RETURN