Panasonic PV-L454 Vhs-c Camcorder - Page 10

Supplying Power (battery Charge/use/refresh/care, Ac Adaptor, Car Battery Cord), Supplying Power - camcorder

Get Panasonic PV-L454 - Palmcorder Camcorder - 270 KP PDF manuals and user guides
UPC - 037988977505
View all Panasonic PV-L454 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 10 highlights

Supplying Power • We recommend using Panasonic's Battery. • We cannot guarantee the quality of this Camcorder when batteries of other companies are used. Charging the Battery Pack Charge Battery Pack fully before use. 23 POWER Lamp 1 CHARGE Lamp A B (Top View) Using the Battery Pack 1 Plug in AC Adaptor. POWER Lamp lights. 2 Insert Battery. A Align left side of Battery with left edge of AC Adaptor. B Press Battery down and slide in direction of arrow. The CHARGE Lamp flashes, then stays lit when charging is complete. 3 Remove Battery. Slide Battery to the left and lift off. Note: • Charging takes about 50 minutes (PV-L354) or 1.5 hours (PV-L454). • While the DC Power Cable (supplied) is connected to the AC Adaptor, the Battery cannot be charged. • After charging 5 times, use Battery Refresh feature as explained below. • Battery life gradually decreases after repeated use and recharging. If operation time becomes very short even after a sufficient charge, discard Battery properly (pages 11, 35). A fully charged Battery provides a maximum of about 1 hour (PV-L354) or 2 hours (PV-L454) of continuous use (LCD monitor off) or about 40 minutes (PV-L354) or 1.5 hours (PV-L454) (LCD monitor on). Actual time may vary due to operating conditions. Using the Built-in Light decreases operating time. A Lift up EVF and attach Battery. a Insert top of Battery into top of mounting a surface. b Press and snap into place. Ab B Battery Refresh This feature completely discharges Battery before recharging begins. Use after every 5 charges for optimum Battery performance. REFRESH Lamp BATTERY REFRESH B Remove Battery. Slide BATTERY RELEASE and remove Battery. To use battery refresh, insert Battery on AC Adaptor (see steps 1~2 above), then press BATTERY REFRESH. The REFRESH Lamp lights, then goes out when discharge is complete. Battery charging will then start automatically. If BATTERY REFRESH is pressed by mistake, remove Battery from AC Adaptor and reinsert it for normal charging. Note: • Charging takes about 4 hours (PV-L354) or about 7.5 hours (PV-L454) when Battery Refresh is used. • Battery will not operate in extremely high temperatures. 10 For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at:http://www.panasonic.com/contactinfo

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
10
For assistance, please call : 1-800-211-PANA(7262) or, contact us via the web at:http://www.panasonic.com/contactinfo
Supplying Power
To use battery refresh, insert Battery on AC
Adaptor (see steps 1~2 above), then press
BATTERY REFRESH.
The REFRESH Lamp lights, then goes out when
discharge is complete. Battery charging will then
start automatically.
If
BATTERY REFRESH is pressed by mistake,
remove Battery from AC Adaptor and reinsert it
for normal charging.
Note:
• Charging takes about 4 hours (PV-L354) or
about 7.5 hours (PV-L454) when Battery
Refresh is used.
• Battery will not operate in extremely high
temperatures.
Note:
• Charging takes about 50 minutes (PV-L354) or 1.5
hours (PV-L454).
• While the DC Power Cable (supplied) is connected
to the AC Adaptor, the Battery cannot be charged.
• After charging 5 times, use Battery Refresh feature
as explained below.
• Battery life gradually decreases after repeated use
and recharging. If operation time becomes very
short even after a sufficient charge, discard Battery
properly (pages 11, 35).
Charge Battery Pack fully before use.
Charging the Battery Pack
A fully charged Battery provides a maximum of about 1 hour (PV-L354) or 2 hours (PV-L454)
of continuous use (LCD monitor off) or about 40 minutes (PV-L354) or 1.5 hours (PV-L454)
(LCD monitor on). Actual time may vary due to operating conditions. Using the Built-in Light
decreases operating time.
2
3
BATTERY
REFRESH
REFRESH
Lamp
Using the Battery Pack
POWER
Lamp
CHARGE
Lamp
1
A
(Top View)
B
1
Plug in
AC Adaptor.
POWER Lamp lights.
2
Insert
Battery.
A
Align left side of Battery with left edge of
AC Adaptor.
B
Press Battery down and slide in direction
of arrow.
The CHARGE Lamp flashes, then stays lit
when charging is complete.
3
Remove
Battery.
Slide Battery to the left and lift off.
A
Lift up
EVF
and
attach
Battery.
a
Insert top of Battery into top of mounting
surface.
b
Press and snap into place.
B
Remove Battery.
Slide
BATTERY RELEASE
and remove
Battery.
Battery Refresh
This feature completely discharges
Battery before recharging begins.
Use after every 5 charges for optimum
Battery performance.
b
A
B
a
•
We recommend using Panasonic
’
s Battery.
•
We cannot guarantee the quality of this Camcorder when batteries of other companies are used.