Panasonic PVD4743 PVD4743 User Guide - Page 10

Location of Controls (continued) Rear View of DECK Bold: VCR Function Italic: DVD Function Bold Italic: VCR and DVD Functions AC Power Plug • While plugged into an AC outlet, this DECK consumes 4 W of electrical power in off mode. Component Video Output Connector (Y, PB, PR) (DVD Only) p. 13 VHF/UHF Antenna Output Terminal p.12 VHF/UHF Antenna Input Terminal p. 12 Video Output Connector p. 12 Video Input Connector p. 35 • • Optical Digital Audio Output Connector (DVD Only) p. 15 S-Video Out Connector (DVD Only) pp. 10, 13 Audio Output 2 Connector (L/R) p. 13 Audio Input Connector (L/R) p. 35 Audio Output 1 Connector (L/R) p. 12 The following table shows the status of the output jacks when in VCR or DVD mode. VCR Video Output Audio Out 1 Audio Out 2 YES Component Video Output N/A S-VIDEO OUT N/A DVD YES YES Note • PROG functions on the remote are not available when using Component Video Output and S-VIDEO OUT. Please set TV to either RF INPUT or VIDEO INPUT, and then press PROG. To enjoy PROGRESSIVE SCAN video (1). Connect Component Video Output to the component video input terminals of a television. (See p. 13.) (2). When the PROGRESSIVE button is pressed, the ON lamp lights up (see p. 9) and the PROGRESSIVE SCAN signal is output from the Component Video Output Connector. Note • The PROGRESSIVE button can be operated when the DECK is in DVD function mode. • The screen may shift off-center when using progressive output. Please adjust the screen position if this occurs. (Refer to your TV manual.) • The DECK outputs video signals (not PROGRESSIVE SCAN) from the "VIDEO OUT" and "S- VIDEO OUT" terminals when the ON lamp is lit. 10 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]