Panasonic PVD4743 PVD4743 User Guide - Page 4

Before Using Congratulations on your purchase of one of the most sophisticated and reliable products on the market today. Used properly, it will bring you years of enjoyment. Please fill in the information below. The serial number is on the tag located on the back of your DECK. • Date of Purchase • Dealer Purchased From • Dealer Address • Dealer Phone No. • Model No. • Serial No. Accessories Remote Control LSSQ0374 (PV-D4743) LSSQ0375 (PV-D4743S) Batteries 2 "AA" Disc formats supported by this DECK DECK can play back discs bearing any of the following marks: [Discs Played 8cm (3") or 12cm (5")] Logo Disc type DVD (DVD-Video) DVD-R (DVD-Video formatted discs [finalized]) Video CD CD (CD-DA) CD-R/CD-RW (CD-DA,Video CD formatted discs [finalized]) WMA, MP3, JPEG Discs which cannot be played • DVD with Region No. other than "1" or "ALL" • DVD of PAL system, DVD-Audio, DVD-RAM, DVD-ROM, DVD-RW, DVD+RW, CD-ROM, CDV, CD-G, CVD, SVCD, SACD, Divx Video Disc and Photo-CD Notes • Do not use irregularly shaped discs (e.g. heartshaped), as these can damage the unit. • It may not be possible to play CD-R, CD-RW and DVD-R in all cases due to the type of disc or condition of the recording. Disc Handling RF Coaxial Cable LSJA0372 To order accessories, call toll free 1-800-332-5368. Loading the Batteries 1) Open cover. Handling precautions • Sticking a label on the disc may impair DVD-R playback. • Do not attach sticker to discs. (Do not use discs with exposed adhesive from tape or left over peeled-off stickers.) • Only hold disc by edges as shown below. Fingerprints, dirt and scratches can cause skipping and distortion. • Do not write on label side of disc. • Never use record cleaning sprays, benzine, thinner, static electricity prevention liquids, or any other solvent. Disc tray Disc 2) Insert batteries as marked. 3) Close cover. Battery replacement caution • Do not mix old and new batteries. • Do not mix alkaline with manganese batteries. • Do not try to close disc tray when disc is not properly placed. To clean disc surface With a soft, damp (water only) cloth, gently wipe from the center hole to the outer edge as shown below. (Wiping in a circular pattern will scratch the surface.) If disc is brought from a cold to a warm environment, moisture may form on the disc Wipe away moisture with a soft, dry, lint-free cloth before using disc. (See above.) Improper disc storage Discs could be damaged if stored or left in areas: • exposed to direct sunlight. • that are humid or dusty. • near heat (i.e. heater, radiator, etc.). 4 For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : [email protected]