Panasonic SC-AKX18 SC-AKX18 Owner's Manual (Multi Language) - Page 12

Clock and timers Setting the clock This is a 12-hour clock. 1 Press [SETUP] to select "CLOCK". 2 Press [R, T] to set the time and then press [OK]. To check the time Press [SETUP] to select "CLOCK" and the press [OK]. In standby mode, press [DISPLAY]. Note: Reset the clock regularly to maintain accuracy. Sleep timer The sleep timer turns off the system after the set time. 1 Press [SETUP] to select "SLEEP". 2 Press [R, T] to select the setting (in minutes) and then press [OK]. To cancel, select "OFF". Note: • The remaining time is always shown on the display. The display changes temporarily when you perform other operations. • The play and sleep timer can be used together. • The sleep timer always comes first. Be sure not to set an overlapping time. Play timer (Except for Bluetooth® source) You can set the timer to come on at a certain time to wake you up. Preparation Set the clock. 1 Press [SETUP] to select "TIMER ADJ". 2 Press [R, T] to set the start time and then press [OK]. 3 Re-do step 2 to set the end time. 4 Press [R, T] to select the source you want to play and then press [OK]. To start the timer 1 Press [SETUP] to select "TIMER SET". 2 Press [R, T] to select "SET" and then press [OK]. "#" is shown. To cancel, select "OFF". The system must be turned off for the timer to operate. To check the setting Press [SETUP] to select "TIMER ADJ" and then press [OK]. In standby mode, press [DISPLAY] two times. Note: • The timer starts at a low volume and increases gradually to the preset level. • The timer comes on at the set time every day. • If you turn off the system and then turn on again while the timer is in operation, the timer will not stop at the end time. RQT9899 12