Panasonic SC-AKX18 SC-AKX18 Owner's Manual (Multi Language) - Page 15

█ Main unit displays "ADJUST CLOCK" • The clock is not set. Adjust the clock. "ADJUST TIMER" • The play timer is not set. Adjust the play timer. "AUTO OFF" • The system has not been used for 20 minutes and will turn off within a minute. To cancel, press any button. "ERROR" • An incorrect operation was done. Read the instructions and try again. "F61" • Examine and correct the speaker cords connection. • Disconnect the USB device. Turn off the system and then turn on again. "F70" • Examine the Bluetooth® connection. • Disconnect the Bluetooth® device. Turn off the system and then turn on again. "F76" • There is a problem with the power supply. • Disconnect the AC power supply cord and consult your dealer. "F77" • Disconnect the AC power supply cord and consult your dealer. "NODEVICE" • The USB device is not connected. Examine the connection. "NO DISC" • You have not put in a disc. "NO PLAY" "UNSUPPORT" • Examine the content. You can only play supported format. • The system may have a problem. Turn off the system and then turn on again. "NO TRACK" • There is no album or track in the USB device. "PLAYERROR" • You played an unsupported MP3 file. The system will skip that track and play the next one. "REMOTE 1" "REMOTE 2" • The remote control and the main unit are using different codes. Change the code of the remote control. - When "REMOTE 1" is shown, press and hold [OK] and [ ] for a minimum of 4 seconds. - When "REMOTE 2" is shown, press and hold [OK] and [USB/CD] for a minimum of 4 seconds. "TEMP NG" • The temperature protection circuit has been activated, and the system will turn off. Let the unit cool down before turning it on again. • Check that the ventilation opening of the unit is not obstructed. • Ensure this unit is well ventilated. "USB OVER CURRENT ERROR" • The USB device is using too much power. Disconnect the USB device, turn off the system and then turn on again. "VBR-" • The system cannot show the remaining play time for variable bit rate (VBR) tracks. Remote control code When other Panasonic equipment responds to the remote control of this system, change the remote control code for this system. Preparation Press [USB/CD] to select "CD". █ To set the code to "REMOTE 2" 1 Press and hold [USB/CD] on the main unit and [RADIO/AUX] on the remote control until "REMOTE 2" is shown. 2 Press and hold [OK] and [USB/CD] for a minimum of 4 seconds. █ To set the code to "REMOTE 1" 1 Press and hold [USB/CD] on the main unit and [USB/CD] on the remote control until "REMOTE 1" is shown. 2 Press and hold [OK] and [ ] for a minimum of 4 seconds. System memory reset Reset the memory when the following situations occur: • There is no response when buttons are pressed. • You want to clear and reset the memory content. 1 Disconnect the AC power supply cord. 2 While you press and hold [1] on the main unit, connect the AC power supply cord again. Continue to press and hold the button until is shown. 3 Release [1]. All the settings are set back to the factory defaults. It is necessary to reset the memory items. 15 RQT9899 ENGLISH