Panasonic SC-PMX150 Owners Manual - Page 7
Method 3, Using an Internet browser
View all Panasonic SC-PMX150 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
The operations and on-screen display items, etc. of the app "Panasonic Music Streaming" are subject to change. For the latest information, visit http://panasonic.jp/support/global/cs/audio/app/ (This site is in English only.) • iOS device: If "Panasonic PMX150 appears under "SET UP NEW AIRPLAY SPEAKER..." instead, proceed to perform steps 5 to 7 of "Method 1" to complete the network setting procedure. (> 6) • Make sure that DHCP is enabled for the network setting on your compatible device. Method 3: Using an Internet browser • The following explanations are based on a smartphone. 1 Turn this system on. 2 Press [RADIO, EXT-IN] on the remote control repeatedly to select "NETWORK". 3 To enter "Setting" mode 1 Press [SETUP] on the remote control repeatedly to select "Net Setup" and then press [OK]. 2 Press [2, 1] on the remote control to select "Manual" and then press [OK]. 3 Press [2, 1] on the remote control to select "OK? Yes" and then press [OK]. • After pressing [OK] to confirm "OK? Yes", the previous network connection you have set with this unit will be cleared. • Alternatively, while pressing and holding down [ 8, "To make network-related settings") 7 Select your security options for this system. To set the AirPlay password 1 Select "Yes" and then select "Next". 2 Set your password and then select "Next". • You will need this password the next time this network setting method is used. • If you have performed a network reset (> 17) , the password will be cleared. To skip this setting Select "No" and then select "Next". • You can also change this setting after the network connection is set up. (> 8, "To make network-related settings") 8 Select your network name (SSID) and type the password. • Check the wireless router for the network name (SSID) and the password. • A list of network names (SSIDs) will be appeared when you select the "Network Name" box. • To show the characters typed in the "Password" box, select "Show Password". • If your network requires specific settings, deselect "DHCP" to disable DHCP. - You can use specific IP address, subnet mask, default gateway, primary DNS, etc. • To update the network name (SSID) list, select "Refresh list". 9 Select "Connect" to apply the settings. Refresh list • On the main unit's display, "Success" appears when the connection is established. (" " will be displayed.) - If "Fail" is displayed press [OK], check the network name (SSID) and the password, and then try the setting again. • Depending on the device, the connection complete screen may not be displayed. 10 Make sure to connect your compatible device back to your home wireless network. Note: • Enable Java and Cookies in your browser settings. 7 TQBJ0996