Panasonic SR-ZG185 Operating Instructions - Page 5

Time setup / Lithium battery Time setup 1 Connect the power plug. Press or button for more than one second, then release the button after a beep sound. The time shows in the LCD starts to blink. 2 Press or button to set the time (1 minute increment). Keeping the button pressed will make setting faster. • 24:00 is replaced by 0:00. • Error may occur in the Timer function if the current time has not been set properly. • The time cannot be setup during operating state. 3 The time will be automatically set after leaving about 5 seconds (LCD stops blinking). Lithium battery ■Power source for the clock When unplugged The internal lithium battery is fully utilized. ■ When plugged The power supply source is fully utilized. Battery Replacement If lithium battery is fully utilized, please ■contact authorized service center for replacement. The life time of battery is around 5 years (At 20°C room temperature and plugged in 12 hours each ■ day). When the battery is consumed, the following phenomenon will happen: • The clock becomes vague or disappear. • Memory of preset time is lost. • The clock can be used again when power plug is connected. (The clock resetting is required). Note: Do not put the lithium battery into the fire, do not recharge, disassemble or heat the battery, etc. 5