Panasonic WVNP1000 WVNP1000 User Guide - Page 59
Con the B/W mode settings, Step 1, AUTO1, Default, Notes
View all Panasonic WVNP1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Configure the B/W mode settings Configure the settings relating to the B/W mode such as brightness at change between colour and B/W, waiting time to change to the B/W mode, etc. Step 1 Press the [SET] button after moving the cursor onto "BW MODE" on the "CAMERA SETUP" page. → The "BW MODE" page will be displayed. **BW MODE** BW AUTO1 LEVEL HIGH DURATION TIME .|.. S L BURST(BW) OFF Step 3 Move the cursor onto "LEVEL" and select a parameter from the following. LOW: When illuminance around the camera is approx. 1 lx or less, images will be automatically displayed in B/W. HIGH: When illuminance around the camera is approx. 5 lx or less, images will be automatically displayed in B/W. Default: HIGH RET TOP END Step 2 Move the cursor onto "BW" and select a parameter from the following. AUTO1: Images will be automatically switched between colour and B/W according to brightness (illumination). When illuminance is low, images will be displayed in B/W. When illuminance is high, images will be displayed in colour. AUTO2: Click this button when using the camera in the nighttime with near-infra red rays as light source. EXT: Images will be displayed in B/W by making "DAY/NIGHT IN" terminal short-circuit. ON: Images will be displayed in B/W. OFF: Images will be displayed in colour. Default: OFF Note: When shooting a constantly moving subject or when the screen is filled by similar colours, it may be difficult for the camera to judge where the light source is, since light source is simplistatically detected according to information from the CCD image sensor. When "AUTO2" is selected, wavelength of light source should be 80 nm or more. Step 4 Move the cursor onto "DURATION TIME" and select a parameter (wait time to switch between the colour mode and the B/W mode) from the following. 10 s - 30 s - 60 s - 300 s (S) (L) Default: 30 sec Step 5 Move the cursor onto "BURST (BW)" and select "ON" or "OFF" to determine whether or not to output burst signals when displaying images in B/W. ON: Output burst signals OFF: Does not output burst signals Default: ON Notes: • It is also possible to make the camera to adjust the flange-back length automatically to correct out-offocus which may be caused when switching between the colour image display and the BW image display. ( page 52) • When displaying colour images in B/W, images may not be displayed correctly without burst signals depending on a monitor or a VTR. In this case, select "ON". 59