Panasonic WVNS202A WVNS202A User Guide - Page 12
Rear view, About the [INITIAL SET] button
View all Panasonic WVNS202A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Rear view Link LED Network connector DC 12 V power terminals Power LED [INITIAL SET] button Cable guide Access LED Audio output connector 10BASE-T/ 100BASE-TX LINK ACT INITIAL SET POWER 4 3 2 1 MIC IN AUDIO OUT MONITOR OUT 12V IN EXT I/O Monitor out connector Safety wire holder Microphone in connector External I/O terminals • About the [INITIAL SET] button Turn on the power of the camera while holding down this button, and wait for around 5 seconds without releasing this button. Wait another 1 minute after releasing the button. The camera will restart and the settings including the network settings will be initialized. The settings including the network settings will be initialized. Note that the preset position settings will not be initialized. Screw hole for a tripod (1/4-20UNC) Important: Use this hole only when the camera is to be installed on desktop using a tripod. Do not use this hole to mount on the ceiling since the fall prevention measure is unavailable. 12