Paradigm Soundscape Manual - Page 17

REMOTE CONTROL The Soundscape's Remote (Fig. 14) controls the following: 'POWER ON/OFF': Turns the Soundscape on or off. 'PREVIOUS SOURCE' / 'NEXT SOURCE': Cycles through the inputs. The order of the inputs is: Digital Optical 1 Digital Optical 2 Digital Coaxial Analog RCA Bluetooth. 'VOL+' / 'VOL-': Adjusts volume level up or down. 'MUTE': Mutes the volume. When muted, the Soundscape will display 'MUTE'. Pressing this button a second time will restore the previous volume setting. Additionally, you can turn mute off by pressing either of the volume buttons. 'MENU': Allows you to enter the Soundscape Menu. Once the menu is activated, use the 'Scroll Up' / 'Scroll Down' / 'Scroll Left' / 'Scroll Right' arrows to access menu features. Press the 'Select' button to accept the various selections. 'SOURCE': Press to cycle through the inputs for playback: Digital Optical > Digital Coaxial > Analog RCA > Bluetooth. 'ENABLE BLUETOOTH': Press to enable wireless music streaming from your Bluetooth-enabled mobile phone or other device. Device must be synced with the Soundscape prior to listening. For syncing instructions and maximum range for wireless streaming, see Wireless Bluetooth Connection instructions, page 13. 'PLAY' / 'PAUSE': Press to play or pause Bluetooth wireless music playback. 'PREVIOUS TRACK': Press to return to the previous track during Bluetooth wireless music playback. 'NEXT TRACK': Press to move to the next track during Bluetooth wireless music playback. 'MUSIC MODE': Press to enable 2-channel music listening 'MOVIE MODE': Press to activate Paradigm Virtual Surround for a full 5.1 virtual surround sound listening experience. Power On/O Scroll Left/ Prev Source Select Source Enable Bluetooth Previous Track Movie Mode* Fig. 14 PROGRAMMING A SECOND REMOTE: The Soundscape can be programmed to respond to a second remote. See the 'IR Learning' section of this manual for programming instructions. Menu Volume Up/ Scroll Up Scroll Right/ Next Source Volume Down/ Scroll Down Mute Play/Pause Next Track MODE Music Mode* * Sonic enhancements to listening experience according to mode CHANGING THE REMOTE'S BATTERY Your Soundscape's remote control unit uses two (2) AAA batteries. Access these batteries by releasing the clip at the bottom in the rear of the remote control. CAUTION! Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent battery type. EN-16