Paradigm Soundscape Manual - Page 8
Placement - manual
View all Paradigm Soundscape manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
PLACEMENT Cont'd ON A WALL ACTION REQUIRED: When mounting Soundcsape on a wall for best results, adjust the unit's equalization and voicing to make sure you are achieving the best sound for the location. Remove feet, if desired, before wall mounting. Use the Soundscape's internal menu system to choose: INSTAL > ON WALL. Paradigm does NOT supply screws and anchor bolts to mount Soundscape to a wall. Choose screws and anchor bolts appropriate for size and weight of Soundscape. Dimensions of Soundscape (H x W x D): 5-1/2˝ x 42˝ x 5˝ / 14 cm x 106.7 x 12.7 cm. Weight of Soundscape: 20 lb / 9.1 kg We provide limited instructions for wall mounting, please contact your Paradigm Dealer for more detailed information. The instructions that follow assume the mounting surface is drywall with standard wood studs. Should you wish to mount to another type of surface please consult a certi ed contractor or your Paradigm Dealer before you begin the installation. What's included 1 x Wall-Mounting Bracket and 2 x Levelling Screws Tools recommended (not included) 1 x Stud Finder 1 x Level 1 x Electric drill and appropriate drill bits Hardware (not included) 5 x Screws appropriate to mounting surface and weight of Soundscape. 5 x Wall anchors appropriate to mounting surface and weight of Soundscape. Wall-Mounting Instructions Follow the directions below and use the illustrations (Figs. 2 - 8) and bottom centermost screw locations as your screw provided on the following pages for guidance. 1 Decide on mounting location and use a level to make sure locations. Use a level to square the bracket and mark the remaining pilot hole locations (Fig. 5). Soundscape's Wall-Mounting bracket sits level (Fig. 2). 6 Remove the wall bracket or pivot bracket to allow access 2 Mark the three center pilot hole screw locations (Fig. 3). 3 Use a stud finder to determine if there is a stud behind one of the three center screw locations (not shown). If a stud is found drill a pilot hole. If no stud is found use the centermost screw location and drill a pilot hole for a wall anchor. Install wall anchor (not shown). to the remaining screw locations. a) If a stud is found, drill pilot holes. b) If no stud is found drill pilot holes and install wall anchors. 7 Using the screws, attach the wall bracket to the wall. DO NOT fully tighten (Fig. 6). 8 Use a level to square the bracket, then tighten all screws (Fig. 7). 4 Using a screw, attach the bracket to the wall. DO NOT tighten the screw at this point (Fig. 4). 9 Attach audio and power cables. Refer to 'CONNECTION' section of this manual for more information. 5 Use a stud finder to determine if a stud lies behind any of 10 Move Soundscape into place. Drop the shoulder bolts the left and right screw locations. If a stud is found the into the wall bracket keyholes (Fig. 8). Before releasing, EN-7 top and bottom screw holes with a stud behind them are make sure the Soundscape has dropped fully into the your screw locations. If no stud is found use the top keyholes and is rmly in place (Fig. 8 Inset).