Pentax K10D User Manual - Page 222
Refer to p.11 of the PENTAX PHOTO Browser 3/PENTAX PHOTO - repair
UPC - 027075121492
View all Pentax K10D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 222 highlights
220 Problem Cause Remedy AE lock function does not operate Flash does not discharge AE lock is not available when set to B (Green), p (Bulb) or M (Flash X- sync speed) mode Use AE lock with any setting other than B (Green), p (Bulb) or M (Flash X-sync speed) mode. Capture mode is set to B (Green) mode. Only C (Auto discharge) and D (Auto flash+Redeye reduct) are available for Flash Mode when Capture mode is B. Flash will not discharge when the subject is bright in these modes. In Capture modes other than B, only the flash mode that discharges every time the flash recharges is available. Try different Capture modes. USB connection with computer does not work properly* The Transfer Mode is set to [PictBridge] An error occurred while sending USB data Set Transfer Mode to [PC]. Change the Transfer Mode to [PC-F]. Appendix USB 5 connection with printer does not work The Transfer Mode is set to [PC] or [PC-F] Set Transfer Mode to [PictBridge]. (p.110) properly Shake Reduction function is off Turn on the Shake Reduction switch. Shake Reduction does not work Shake Reduction function is not set properly Shutter speed is too low for Shake Reduction function to be effective when panning or shooting night scenes, etc. If a lens for which focal length information cannot be acquired is used, set the [Focal Length] on the [Shake Reduction] menu. (p.69) Turn off the Shake Reduction function and use a tripod. Subject is too close Move away from the subject, or turn off the Shake Reduction function and use a tripod. In rare cases, the camera may not operate correctly due to static electricity. This can be remedied by taking the batteries out and putting them back in again. When the mirror remains in the up position, take the batteries out and put them back in again. Then, turn the power on. The mirror will retract. After the procedure is done, if the camera operates correctly, it does not require any repairs. * Refer to p.11 of the "PENTAX PHOTO Browser 3/PENTAX PHOTO Laboratory 3 Operating Manual" for details on connecting the camera to a PC.