Pfaff creative 1371 Owner's Manual - Page 51

___ Border 1 prog 2935 -3+ 2 First workstep, centre motif • Select program 35 Sew the programmed stitch pattern. Second workstep, heart motif • Select program 29 Sew the programmed stitch pattern, stitching the straight-stitch seam along the centre motif. Border 2 prog- 04 30 :izLL.J Begin by tracing the pattern on a piece of paper, then transfer it onto the fabric First workstep, stems • Select program 04 and sew along the traced lines. Second workstep, leaves • Select program 42 • Stitch width 4.5 mm • Pattern lengths 12-10-9.0-8.0 • Press 'single pattern' key • Sew the leaves, starting at the stem. Third workstep, flowers • Select program 30 • Press "single pattern" key • Press "needle down" key The flowers are produced by turning the fabric. Sew the programmed stitch pattern until the needle stops down in the material. Turn the fabric through 90°. Repeat this process three times. Fourth workstep, flower centre • Select program 42 • Stitch width 5.0 mm • Stitch length 0.25 mm • Pattern length 5.0 Sew the programmed stitch pattern in the middle, as illustrated. Fifth workstep, bud centre • Select program 42 • Stitch width 2.5 mm • Stitch length 0.25 mm • Pattern length 3.0 Sew the programmed stitch pattern, as illus 2 trated. 45