Philips DVP3355V User manual - Page 14

Remote Control Button Media (Alphabetical order) DVD mode • To select chapter or title directly. • To select track directly. VCR mode English Français Español Installing the Batteries for the Remote Control Install two AAA batteries (supplied) matching the polarity indicated inside the battery compartment of the Remote Control. 1 2 3 Keep in mind the following when using the Remote Control: • Make sure that there are no obstacles between the Remote Control and the infrared sensor window on the Unit. • The maximum operable infrared signal ranges from the Remote Control are as follows. - Line of sight: approx. 23 feet (7m) - Either side of center: approx. 16 feet (5m) within 30° - Above: approx. 16 feet (5m) within 15° - Below: approx. 10 feet (3m) within 30° Note(s): • Do not mix alkaline and manganese batteries. • Do not mix old and new batteries. • Always remove batteries from Remote Control if they are dead or if the Remote Control is not to be used for an extended period of time. This will prevent battery acid from leaking into the battery compartment. • If you turn off this Unit, [OPEN/CLOSE A] on the Unit or Remote Control is not available. through a disc. • To begin slow forward/reverse playback in the pause mode. • To search forward/backward through a disc. • To forward/backward a tape. • To begin slow forward playback in the pause mode. • To repeat between your chosen • To repeat between your point A and B. chosen point A and B. • To select camera angles on a disc. • To select audio languages on a disc. • To clear the markers. • To clear numbers entered incorrectly. • To cancel the point for A-B repeat. • To select "STEREO", "L-ch" or "R-ch". • To clear the markers. • To remove status number in program input. • To clear numbers entered incorrectly. • To cancel the point for A-B repeat. • To select "HIFI" or "MONO" mode during playback. (Hi-Fi tapes only) • To exit the VCR menu. • To reset the tape counter. • To call up the disc menu on a disc. • To display the current disc mode. • To display the current disc mode. • To display the current time, tape counter and L1 or L2. • To select DVD output mode. • To select the DVD output mode. • To activate DVD mode. • To activate DVD mode. • To select input "L1" or "L2". • To set black level on/off. • To move the cursor and determine its position. • To arrange the playing order or play randomly. • To move the cursor and determine its position. • To select an item on the VCR menu. • To advance to the next VCR menu. • To go back one step during clock and timer programming. • To open or close the disc tray. • To open or close the disc tray. • To pause disc playback. • To advance playback one frame • To pause disc playback. at a time. • To eject the cassette tape from the cassette compartment. • To pause tape playback or recording. • To advance playback one frame at a time. • To begin disc playback. • To begin disc playback. • To begin tape playback. • To skip chapters or titles. • To skip tracks. • To play back a chapter or title • To play back a track or disc repeatedly. repeatedly. • To return to the previous operation in menu. • To return to the previous operation in menu. • To search chapter, title or time. • To search track. • To search time. • To set or search the markers. • To set or search the markers. • To start recording or one-touch timer recording (OTR). • To select the repeat mode on/ off. • To call up the index or time search menu. • To call up the DVD setup menu. • To call up the DVD setup menu. • To call up the VCR menu. • To select the recording speed. • To turn the Unit on or to turn the • To turn the Unit on or to turn the • To turn the Unit on or to turn the Unit into the standby mode. (To Unit into the standby mode. (To Unit into the standby mode. (To completely turn off the Unit, you completely turn off the Unit, you completely turn off the Unit, you must unplug the AC power cord.) must unplug the AC power cord.) must unplug the AC power cord.) • To stop playback. • To stop playback. • To stop playback or recording. • To select subtitles on a disc. • To call up the top menu on a disc. • To adjust the tracking manually during playback. • To magnify part of a picture. (2x/4x) - 14 - • To put the VCR into standby mode for a timer recording. • To select the VCR output mode. • To activate VCR mode. EN