Philips LC4341 User Guide - Page 22

9. Maintenance Resetting the lamplife time Caution! 1. Press Menu. - For cooling purposes the lamp is open. When removing the - The menu bar appears on the screen. lamp do not tilt. If the inner tube is broken glass particles may 2. Use cursor control to fall out. select Settings in the - Be very careful. The lamp and lampholder may still be too hot menu bar. Display Picture Audio to touch. Language - Keep lamp holder opening to your right. Do not touch lamp or point lamp holder opening at anyone. - A high-pressure lamp may break if handled improperly. Keystone correction Start-up screen Feedback Lamp counter Key lock... 8. Carefully remove the new lamp housing from its package. Do Factory reset... not touch lamp or point lamp housing opening at anyone. Do not drop, as the impact may cause the lamp to break. 9. Place the lamp holder in the guiding slots and insert into the lamp compartment. Settings FILTER 10. Tighten the screws. 11. Replace the cover and tighten the screws. 12. Plug the projector back in by inserting the mains lead in the Power socket. 13. Press the Stand by On button to switch on the projector. 14. Reset the lamp life time (see 'Resetting the lamplife time'). 15. Properly dispose of the old lamp. Note: When replacing the lamp, always use the same type of lamp LCA3111/00, 12NC 8670 931 11009). 3. Use cursor control to select Lamp counter in the sub menu. Display Picture Language Keystone correction Start-up screen Feedback Lamp counter Key lock... Factory reset... Audio Settings Lamp counter 0 hours Lamp counter shows the operating hours of the lamp. It is suggested to reset when a new lamp is inserted. To reset keep confirmation key pressed for 3 seconds. 4. Press OK (-/- -) for 3 seconds to reset the lamp counter. 5. If required, select another item you wish to adjust or press Menu to exit. 22