Philips LC4341 User Guide - Page 8

6. Set Up Positioning the projector and screen • Place the projector on a stable, level surface, out of direct sunlight and away from sources of excessive dust, dirt, heat, water, moisture, vibration and strong magnetic fields. Face the projector towards the screen for the best picture results. To determine the distance for the desired size, please refer to the Projection Assistant, a calculation programme included on the CD-ROM. • The screen should be positioned so that it is not directly touched by sunlight or artificial light, as this will wash out the colours of the picture, making it hard to see. • The projector can be used for both front projection, rear projection and ceiling projection applications. As default factory setting, the projector has been set up for front projection. You can change to rear or ceiling projection via the OSD menu. See 'Rear screen projection' and 'Ceiling-mount projection' under 'Operation - Display and picture control' for further instructions. • Choose a screen size suitable for the number of viewers and the size of the room. • Picture quality is best when you sit directly in front of the projector screen. Mains supply 1. Insert the mains lead into the projectors Power socket and connect it to the wall socket. Note: The standby indicator lights up red, the projector is now in the Power/Standby mode. - The Standby Warning screen will appear for 20 seconds. Warning If the projector is switched off you have to wait 1 minute before you can switch on the projector again. To switch off projector keep stand-by key pressed for 3 seconds. Press OK key to remove this warning. Note: The Stand by Warning screen can be removed by keeping the Stand by On button pressed for 3 seconds. If the Stand by On button is pressed for 3 seconds the first time (step 3), the projector is switched back into the power standby mode without the Standby Warning screen being displayed. 5. To switch off the mains supply completely, pull the mains plug out of the wall socket. Note: Before disconnecting the mains lead, make sure that the cooling fan has stopped (about 3 minutes after the projector has been switched to Power Standby). Stabnyd A MVute Volume Lamp RC Adjusting the focus and size of the image • Use the Zoom ring to adjust the size of the image. • Use the Focus ring to adjust the focus of the image. Keystone Menu OK Stabnyd A MVute Volume Lamp RC Keystone Menu OK Zoom ring Focus ring 2. Remove the lens cap. 3. Press the Stand by On button to switch on the projector. - The lamp indicator flashes green. - When the projection lamp is on, the lamp indicator lights up green while the lamp is starting up and the startup screen appears for several seconds. 4. Press the Stand by On button again to switch the projector back into the power standby mode. PHILIPS Multimedia Projectors Adjusting the vertical and horizontal angle of the projector Vertical angle • Use the Height/Level Adjusters to adjust the vertical angle of the projector as specified under 'Positioning the projector and screen'. A B A B To Raise: • Keep both adjusters (A) pressed and lift to raise the projector. - The projector feet (B) will come out. 8