Philips SWW1800/27 User Manual - Page 13

English Note •• In standby mode, a red power LED displays on the transmitter. •• Depending on equipment and the input selected, between input selection/start-up and being able to see the image on your TV can take up to 15 seconds. Establish the link between the transmitter and receiver A flashing blue power LED displays until the signal like between the two units are established. Normally, it takes around 15-20 seconds for the link to establish successfully. LED indicator status of the transmitter Check the LED indicator status to ensure the link between the transmitter and receiver is established. Mode Standby (Listen mode) Standby (Sleep mode) Startup or RF connection interrupted On with unrecognized video format On with recognized video format Fail to find the video source device Power LED indicator Solid purple Solid red Flashing blue Solid blue Solid blue Solid blue Mode Source LED indicator Standby Off Startup or RF connection Flashing interrupted On with unrecognized video format Flashing slowly (once per second) On with recognized video Solid blue format Fail to find the video source device Flashing quickly (3 times per second) Mode Star tup On with recognized video format Fail to find the video device On screen display (If TV supports CEC) LINK START & LINK VERIFY NoModeSupport NO SIGNAL Select the source on the transmitter Press the source buttons: 1 HDMI , 2 HDMI, 3 INPUT, 4 INPUT on the remote control or transmitter until you see the available video from your device. EN 13