Pioneer AVH-280BT Owner s Manual - Page 32
Connection - steering wheel control
View all Pioneer AVH-280BT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Connection CAUTION Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring to remain exposed. Do not directly connect the yellow lead of this product to the vehicle battery. If the lead is directly connected to the battery, engine vibration may eventually cause the insulation to fail at the point where the wire passes from the passenger compartment into the engine compartment. If the yellow lead's insulation tears as a result of contact with metal parts, shortcircuiting can occur, resulting in considerable danger. It is extremely dangerous to allow cables to become wound around the steering column or shift lever. Be sure to install this product, its cables, and wiring away in such so that they will not obstruct or hinder driving. Make sure that the cables and wires will not interfere with or become caught in any of the vehicle's moving parts, especially the steering wheel, shift lever, parking brake, sliding seat tracks, doors, or any of the vehicle's controls. Do not route wires where they will be exposed to high temperatures. If the insulation heats up, wires may become damaged, resulting in a short circuit or malfunction and permanent damage to the product. Do not shorten any leads. If you do, the protection circuit (fuse holder, fuse resistor or filter, etc.) may fail to work properly. Never feed power to other electronic products by cutting the insulation of the power supply lead of this product and tapping into the lead. The current capacity of the lead will be exceeded, causing overheating. Before installing this product Use this unit with a 12-volt battery and negative grounding only. Failure to do so may result in a fire or malfunction. To avoid shorts in the electrical system, be sure to disconnect the (-) battery cable before installation. To prevent damage WARNING Use speakers over 50 W (output value) and between 4 Ω to 8 Ω (impedance value). Do not use 1 Ω to 3 Ω speakers for this unit. 32 The black cable is ground. When installing this unit or power amp (sold separately), make sure to connect the ground wire first. Ensure that the ground wire is properly connected to metal parts of the car's body. The ground wire of the power amp and the one of this unit or any other device must be connected to the car separately with different screws. If the screw for the ground wire loosens or falls out, it could result in fire generation of smoke or malfunction. Ground wire POWER AMP Other devices Metal parts of car's body (Another electronic device in the car) When replacing the fuse, be sure to only use a fuse of the rating prescribed on this product. This product cannot be installed in a vehicle without ACC (accessory) position on the ignition switch. F ACC O F O OF OF N STAR N STAR T T ACC position No ACC position To avoid short-circuiting, cover the disconnected lead with insulating tape. It is especially important to insulate all unused speaker leads, which if left uncovered may cause a short circuit. For connecting a power amp or other devices to this product, refer to the manual for the product to be connected. Notice for the blue/white lead When the ignition switch is turned on (ACC ON), a control signal is output through the blue/white lead. Connect to an external power amp's system remote control terminal, the auto-antenna relay control terminal, or the antenna booster power control terminal (max. 300 mA 12 V DC). The control signal is output through the blue/white lead, even if the audio source is switched off. This product 1 2 87 65 4 3 1 Microphone 4 m (13 ft. 1 in.) (AVH-280BT) 2 This product 3 Antenna jack 4 Wired remote input Hard-wired remote control adapter can be connected (sold separately). 5 Power supply 6 Fuse (10 A) 7 Front output 8 Rear output or subwoofer output