Pioneer AVIC N4 Other Manual - Page 6

Before installing this, product, To prevent damage, Connecting the System - accessories

Get Pioneer AVIC N4 - Navigation System With DVD player PDF manuals and user guides
UPC - 012562863078
View all Pioneer AVIC N4 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

Section 03 Connecting the System Before installing this product ! This product is for vehicles with a 12-volt battery and negative grounding. Check the battery voltage of your vehicle before installation. ! To avoid shorts in the electrical system, be sure to disconnect the (-) battery cable before beginning installation. ! When the "Antenna Control" mode is set to "Radio", the vehicle's antenna can be stowed or turned off by following the instructions below. - Change the source from radio (AM or FM) to another source - Turn the source off - Turn off the ignition switch (ACC OFF) ! If the "Antenna Control" mode is set to "Power", the vehicle's antenna can be stowed or turned off only when the ignition switch is turned off (ACC OFF). To prevent damage WARNING ! When replacing the fuse, be sure to only use a fuse of the rating prescribed on the fuse holder. - When disconnecting a connector, pull the connector itself. Do not pull the lead, as you may pull it out of the connector. - This product cannot be installed in a vehicle that does not have an ACC (accessory) position on the ignition switch. F ACC O F O OF OF N STAR N STAR T T ACC position No ACC position ! To avoid short-circuiting, cover the disconnected lead with insulating tape. It is especially important to insulate all unused speaker leads, which if left uncovered may cause a short circuit. ! Attach the connectors of the same color to the corresponding colored port, i.e., blue connector to the blue port, black to black, etc. ! Refer to the owner's manual for details on connecting the power amp and other units, then make connections accordingly. ! Since a unique BPTL circuit is employed, do not directly ground the * side of the speaker lead or connect the * sides of the speaker leads together. Be sure to connect the * side of the speaker lead to the * side of the speaker lead on this navigation system. ! If the RCA pin jack on this product will not be used, do not remove the caps attached to the end of the connector. ! Never connect speakers with an output rating of less than 50 W channel or impedance outside of the 4 ohms to 8 ohms specifications to your navigation system. Connecting speakers with output and/or impedance values other than those noted here may result in the speakers catching fire, emitting smoke, or becoming damaged. 6 En

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
Before installing this
product
!
This product is for vehicles with a 12-volt
battery and negative grounding. Check the
battery voltage of your vehicle before instal-
lation.
!
To avoid shorts in the electrical system, be
sure to disconnect the (
–
) battery cable be-
fore beginning installation.
To prevent damage
WARNING
!
When replacing the fuse, be sure to only
use a fuse of the rating prescribed on the
fuse holder.
—
When disconnecting a connector, pull the
connector itself. Do not pull the lead, as
you may pull it out of the connector.
—
This product cannot be installed in a vehi-
cle that does not have an ACC (accessory)
position on the ignition switch.
A
C
C
O
N
S
T
A
R
T
O
F
F
O
N
S
T
A
R
T
O
F
F
ACC position
No ACC position
!
When the
“
Antenna Control
”
mode is set
to
“
Radio
”
, the vehicle
’
s antenna can be
stowed or turned off by following the in-
structions below.
—
Change the source from radio (AM or
FM) to another source
—
Turn the source off
—
Turn off the ignition switch (ACC OFF)
!
If the
“
Antenna Control
”
mode is set to
“
Power
”
, the vehicle
’
s antenna can be
stowed or turned off only when the ignition
switch is turned off (ACC OFF).
!
To avoid short-circuiting, cover the discon-
nected lead with insulating tape. It is espe-
cially important to insulate all unused
speaker leads, which if left uncovered may
cause a short circuit.
!
Attach the connectors of the same color to
the corresponding colored port, i.e., blue
connector to the blue port, black to black,
etc.
!
Refer to the owner
’
s manual for details on
connecting the power amp and other units,
then make connections accordingly.
!
Since a unique BPTL circuit is employed,
do not directly ground the
*
side of the
speaker lead or connect the
*
sides of the
speaker leads together. Be sure to connect
the
*
side of the speaker lead to the
*
side of the speaker lead on this navigation
system.
!
If the RCA pin jack on this product will not
be used, do not remove the caps attached
to the end of the connector.
!
Never connect speakers with an output rat-
ing of less than 50 W channel or impe-
dance outside of the 4 ohms to 8 ohms
specifications to your navigation system.
Connecting speakers with output and/or
impedance values other than those noted
here may result in the speakers catching
fire, emitting smoke, or becoming da-
maged.
Connecting the System
En
6
Section
03