Pioneer AVIC-Z2 Installation Manual - Page 15

Chapter 2 How to Use the Navigation System and Names of the Parts ❒ To cancel standby mode, press the V button again, or touch the screen. When Using the Navigation System for the First Time The navigation system cannot detect the location correctly if the initial learning is not complete. The correct positioning can be attained after driving a certain distance. (The AV source can be used normally regardless of the initial learning status.) When the vehicle starts to run, the 3D Hybrid Sensor's initial learning automatically starts. Until the 3D Hybrid Sensor's initial learning is complete, the positioning is performed by GPS satellites so the location of your vehicle may not be very accurate. This is not an error. When the initial learning is complete, the location of your vehicle can be detected with high accuracy. ❒ When an error message appears during the initial learning, refer to "Message and how to react to them" in the Operation Manual. Selecting a Source with the AV button 1 Turn the ignition switch (ACC) ON. The navigation system's power supply comes on. 2 After the navigation system starts, press the AV button to switch the screen. The navigation map screen changes to the audio source screen. 3 Press the AV button to turn the audio source on. 4 Press the AV button to select a source. Press the AV button repeatedly to switch between the following sources: [CD/ROM (MP3)/DVD] (built-in DVD drive) - [LIBRARY] (HDD player) - [FM] (FM tuner) - [AM] (AM tuner) - [XM] (XM tuner) - [SIRIUS] (SIRIUS tuner) - [iPod] (iPod) - [M-CD] (multi-CD) - [TV] (television) - [AV INPUT] (video input) - [AUX] (Auxiliary equipment) - [EXT 1] (external unit 1) - [EXT 2] (external unit 2) ❒ Press and hold the AV button to turn the source off. ❒ In the following cases, the sound source cannot be used: - When a unit corresponding to the source is not connected to the navigation system. - When no disc is set in the navigation system. - When no magazine is set in the multi-CD player. - When [AUX Input] (auxiliary input) is turned off (refer to Operation Manual). - When [AV Input] (video input) is not set to [Video] (refer to Operation Manual). ❒ "External unit" refers to a Pioneer product (such as one available in the future) where, although it is incompatible as a source, the basic functions can be controlled by the navigation system. Two external units can be controlled by this navigation system. When two external units are connected, the navigation system allocates them to external unit 1 or external unit 2. ❒ When the [Auto ANT] mode is set to [Radio], the vehicle's antenna can be stowed or turned off by following one of the steps below. - Change the source from radio (AM or FM) to another source. - Turn the source off. - Turn off the ignition switch (ACC OFF). If the [Auto ANT] mode is set to [Power], the vehicle's antenna can be stowed or turned off only when the ignition switch is turned off (ACC OFF). ➲ [Auto ANT] ➞ Operation Manual Adjusting the Volume • Use the VOL (/) button to adjust the audio sound level. Press the VOL (/) button to increase or decrease the volume. ❒ To adjust the navigation volume, go to the navigation menu. ➲ Navigation volume adjustment ➞ Operation Manual 13