Pioneer BDP 320 Owner's Manual - Page 62

07 Problem Check Software updating is slow. Remedy Depending on the Internet connection and other conditions, some time may be required to update the software. • "WRT NG ****" is displayed on the front panel display during software updating. (**** meaning any characters) • "WRT FAILED" is displayed on the front panel display during software updating. The message is displayed when software updating has failed. Check again whether it can be updated properly. A message other than "Network connection test completed successfully" is displayed when Connection Test is performed. Is "LAN cable not connected" Check that this player and Ethernet hub (or router with hub displayed? functionality) are properly connected. • Is "IP address cannot be obtained." displayed? • Is "No response from the gateway." displayed? • If the IP address is obtained using the DHCP server function, check the setting is correct at the Display Network Configuration (page 44). For details on the DHCP server function, see the operating instructions of the Ethernet hub (or router with hub functionality). • Set the IP address manually. Is "IP address is overlapped." • Check the operation and settings of the DHCP server function of the displayed? Ethernet hub (or router with hub functionality). For details on the DHCP server function, see the operating instructions of the Ethernet hub (or router with hub functionality). • If this player's has been set manually, reset the IP address of this player or other components. Is the Ethernet hub (or router • Check the settings and operation the Ethernet hub (or router with hub with hub functionality) functionality). For details, see the operating instructions of the Ethernet operating properly? hub. • Reboot the Ethernet hub (or router with hub functionality). Others Problem Check Remedy The player's power turns off Is Auto Power Off set to automatically. On? If Auto Power Off is set to On, the player's power turns off automatically if no operation is performed for over 30 minutes (page 41). Is Display Power Off set to On? The player's power may turn off together with the power of the TV connected to the HDMI OUT terminal. If you do not want the player's power to turn off when the TV's power is turned off, set Display Power Off to Off (page 39). The player's power turns on Is KURO LINK set to On? automatically. The player's power may turn on together with the power of the TV connected to the HDMI OUT terminal. If you do not want the player's power to turn on when the TV's power is turned on, set KURO LINK to Off (page 39). Player cannot be operated with remote control. Is an AV receiver or amplifier Operate with the remote control of the device connected to the connected to the CONTROL CONTROL IN terminal. IN terminal on the player's rear panel? Are you operating the remote Operate from within 23 feet (7 m) of the remote control sensor. control from a point too far away from the player? Are the batteries dead? Replace the batteries (page 7). Input of connected TV and AV Is KURO LINK set to On? system switches automatically. The input of the TV and AV system (AV receiver or amplifier, etc.) connected to the HDMI OUT terminal may automatically switch to the player when playback starts on the player or the menu screen (Home Media Gallery, etc.) is displayed. If you do not want the inputs of the connected TV and AV system (AV receiver or amplifier, etc.) to switch automatically, set KURO LINK to Off (page 39). "Processing failed." is 62 displayed. If the message appears repeatedly, please ask your nearest Pioneer authorized service center or your dealer to carry out repair work. En