Pioneer DDJ-T1 Owner's Manual - Page 13

Connections Connections Be sure to turn off the power and unplug the AC adapter from the power outlet before making or changing connections between devices. Wait until all connections between devices have been completed before connecting the AC adapter. Only use the AC adapter included with this unit. Refer to the operating instructions for the component to be connected. Power to this unit is supplied by the AC adapter or by USB bus power. This unit can be used by connecting it to a computer using a USB cable, even without connecting the AC adapter. ! Connect this unit and the computer directly using the included USB cable. ! A USB hub cannot be used. ! When using USB bus power, use the connected computer on an AC power supply. ! In cases like the ones below, the power may be insufficient and this unit may not operate on USB bus power. - When the computer's USB power supply capacity is insufficient. - When other USB devices are connected to the computer. If this unit does not operate on USB bus power, connect the included AC adapter. ! The following limitations apply when operating on USB bus power: - The jog dial indicator will not light. - The indicators (aside from the jog dial) will be dimmer. - The [AUX IN] and [MIC] terminals cannot be used. - The volume of the headphones will be lower. To use the unit without these limitations, connect the included AC adapter. Names of terminals Rear panel 1 2 34 5 678 9 MASTER OUT 1(TRS) R R LR L MIN MAX L MASTER OUT 2 AUX IN VOL USB ON OFF DC IN 1 MASTER OUT 1 terminal Connect powered speakers, etc., here. This is a TRS phone jack, so both balanced and unbalanced outputs are supported. ! The sound will be distorted if the level is raised too high when using unbalanced outputs. 2 MASTER OUT 2 terminal Connect to a power amplifier, etc. 3 AUX IN terminal Connect to the output terminal of an external device (sampler, portable audio device, etc.) ! This cannot be used when operating on USB bus power. 4 VOL control Adjusts the audio level input to the [AUX IN] terminals. 5 Kensington security slot 6 USB terminal Connect to a computer. ! Connect this unit and the computer directly using the included USB cable. ! A USB hub cannot be used. 7 ON/OFF switch Turns this unit's power on and off. 8 DC IN terminal Connect to a power outlet using the included AC adapter (with the power plug mounted). Wait until connection of all equipment is completed before connecting the AC adapter. Only use the included AC adapter. 9 Cord hook Catch the AC adapter's power cord and USB cable on this hook when using this unit. For details, see Cord hook on page 14. ! The sound will be interrupted if the AC adapter or USB cable is disconnected during playback. En 13