Pioneer DEH 2000MP Owner's Manual - Page 12

Section 02 Operating this unit 3 Press a or b to adjust the source volume. SLA +4 to SLA -4 is displayed as the source volume is increased or decreased. # To return to the normal display, press BAND. Other Functions Adjusting initial settings Using the initial settings, you can customize various system settings to achieve optimal performance from this unit. 1 Press SOURCE and hold until the unit turns off. 2 Press SOURCE and hold until function name appears in the display. 3 Press FUNCTION to select one of the initial settings. Press FUNCTION repeatedly to switch between the following settings: Clock-AUX (auxiliary input) Use the following instructions to operate each particular setting. # To cancel initial settings, press BAND. # You can also cancel initial settings by holding down SOURCE until the unit turns off. ! Even when the sources are off, the clock display appears on the display. % Press CLOCK to turn the clock display on or off. Each press of CLOCK turns the clock display on or off. # The clock display disappears temporarily when you perform other operations, but the clock display appears again after 25 seconds. Switching the auxiliary setting It is possible to use auxiliary equipment with this unit. Activate the auxiliary setting when using auxiliary equipment connected to this unit. 1 Press FUNCTION to select AUX. 2 Press a or b to turn the auxiliary setting on or off. Setting the clock Use these instructions to set the clock. 1 Press FUNCTION to select clock. 2 Press c or d to select the segment of the clock display you wish to set. Pressing c or d will select one segment of the clock display: Hour-Minute 3 Press a or b to set the clock. Turning the clock display on or off You can turn the clock display on or off. 12 En