Pioneer DEH-P600UB Owner's Manual - Page 51

Available accessories Section 06 Available accessories 1 2 34 3 Press DIRECT. The XM channel of entered number is selected. # After entering the number input mode, if you do not perform an operation within about eight seconds, the mode is automatically canceled. 5 1 XM band indicator 2 XM channel number indicator 3 XM preset number indicator 4 XM channel select setting indicator Shows what channel select setting has been selected. CH is displayed when Channel number is selected, and CAT is displayed when Category is selected. 5 XM text information Shows the text information of broadcast channel. % Select an XM band. Press BAND. # Band can be selected from XM-1, XM-2 or XM-3. % Select a channel. Push MULTI-CONTROL left or right. # If you push and hold MULTI-CONTROL left or right, you can increase or decrease channel number continuously. # You can also perform tuning from a desired channel category. (Refer to Selecting a channel in the channel category on the next page.) Selecting an XM channel directly When using the remote control, you can select the XM channel directly by entering the desired channel number. 1 Press DIRECT. Channel number input display appears. 2 Press 0 to 9 buttons to enter the desired channel number. # You can cancel the input number by pressing CLEAR. Switching the XM display % Press DISP to switch the XM display. # You can scroll the text information to the left by pressing and holding DISP. Storing and recalling broadcast stations You can easily store up to six broadcast stations for later recall. ! Six stations for each band can be stored in memory. 1 Press LIST. Preset screen is displayed. 2 Use MULTI-CONTROL to store the selected station in memory. Turn to change the preset number. Press and hold to store. The XM preset number you have selected will flash and then remain lit. The selected station has been stored in memory. 3 Use MULTI-CONTROL to select the desired station. Turn to change the station; press to select. # You can also change the station by pushing MULTI-CONTROL up or down. # If you do not operate the list within about 30 seconds, the display is automatically returned to the ordinary display. En 51