Pioneer DEQ-P8000 Owner's Manual - Page 12
Setting the speaker setting, Digital Signal Processor - installation
UPC - 012562693569
View all Pioneer DEQ-P8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Section 03 Digital Signal Processor 5 Touch to turn the panorama control on. # To turn the panorama control off, touch . 6 Touch and then touch or to adjust front/surround speaker balance. Each time you touch or it moves the sound towards the front or the surrounds. +3 3 is displayed as the front/surround speaker balance moves from front to surrounds. 7 Touch and then touch or to adjust the center image. Each time you touch or it gradually spreads the center channel sound into the front left and right speakers over a range 07. 3 is the default and its recommended for most recordings. 0 places all center sound in the center speaker. 7 places all center sound equally in the left/right speakers. Setting the speaker setting You need to make with/without (or yes/no) and size (bass reproducing capacity) selection/adjustments depending on the installed speakers. The size needs to be set to LARGE (large) if the speaker is capable of reproducing sounds of about 100 Hz or below. Otherwise select SMALL (small). ! Low frequency range is not output if the subwoofer is set to OFF and the front and rear speakers set to SMALL or OFF. ! It is imperative that non-installed speakers be set to OFF. ! Set the front or rear speaker to LARGE if the speaker is capable of reproducing bass content, or if no subwoofer is installed. 1 Touch A.MENU and DSP and then touch NEXT. 2 Touch SPEAKER SETTING. 3 Touch or to select the speaker to be adjusted. Each time you touch or selects the speaker in the following order: FRONT (front speakers)CENTER (center speaker)REAR (rear speakers) SUB WOOFER (subwoofer)PHASE (subwoofer setting) # You can switch to PHASE only when the subwoofer has been set to ON. 4 Touch or to select the correct size for the selected speaker. Each time you touch or selects the size in the following order: OFF (off)SMALL (small)LARGE (large) # You cannot select OFF, when FRONT (front speakers) have been selected. # You can select ON or OFF, when SUB WOOFER (subwoofer) has been selected. # You can switch REVERSE (reverse phase) or NORMAL (normal phase), when PHASE (subwoofer setting) has been selected. Correcting the subwoofers phase If trying to boost the bass output of the subwoofer doesnt do much or rather makes you feel that the bass gets more murky, this may indicate that the subwoofers output and bass content you hear over other speakers cancel each other out. To remove this problem, try changing the phase setting for the subwoofer. 1 Touch A.MENU and DSP and then touch NEXT. 2 Touch SPEAKER SETTING. 12 En