Pioneer DEQ-P8000 Owner's Manual - Page 17
Using the auto-equalizer, Auto TA and EQ auto-time, alignment and auto, equalizing, Digital Signal - microphone
UPC - 012562693569
View all Pioneer DEQ-P8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Digital Signal Processor Section 03 English 8 Touch and then touch or to select the desired Q factor. Each time you touch or switches between the following Q factor: WIDE (wide)NARROW (narrow) # You can adjust parameters for each band of the other speakers in the same way. Note You can select a center frequency for each band. You can change the center frequency in 1/3-octave steps, but you cannot select frequencies that have intervals shorter than 1 octave among the center frequencies of the three bands. Auto TA and EQ (auto-time alignment and autoequalizing) This function cannot be operated when DVHP7000, DVH-P5000MP or AVH-P6500DVD is connected to this unit. The auto-time alignment is automatically adjusted for the distance between each speaker and the listening position. The auto-equalizer automatically measures the car interior acoustic characteristics, and then creates the auto-equalizer curve based on that information. Using the auto-equalizer This function cannot be operated when DVHP7000, DVH-P5000MP or AVH-P6500DVD is connected to this unit. The auto-equalizer is the equalizer curve created by auto TA and EQ (refer to Auto TA and EQ (auto-time alignment and auto-equalizing) on this page). You can turn the auto-equalizer on or off. 1 Touch A.MENU and DSP and then touch NEXT twice. 2 Touch AUTO EQ. # You cannot use this function if auto TA and EQ has not been carried out. 3 Touch a to turn the auto-equalizer on. # To turn auto-equalizer off, touch b. WARNING To prevent accidents, never carry out auto TA and EQ while driving. When this function measures the car interior acoustic characteristics to create an auto-equalizer curve, a loud measurement tone (noise) may be outputted from the speakers. CAUTION ! Carrying out auto TA and EQ under the follow- ing conditions may damage the speakers. Be sure to check the conditions thoroughly before carrying out auto TA and EQ. When speakers are incorrectly connected. (e.g., When a rear speaker is connected to a subwoofer output.) When a speaker is connected to a power amp delivering output higher than the speakers maximum input power capability. ! If the microphone is placed in an unsuitable position the measurement tone may become loud and measurement may take a long time, resulting in a drain on battery power. Be sure to place the microphone in the specified location. En 17