Pioneer DEQ-P8000 Owner's Manual - Page 22

Appendix Additional Information Symptom No sounds are heard. Cause Optical cables are incorrectly connected. Action Connect the cables correctly. (Page 4) DVD player setting Symptom No sounds come from the DVD player only. Cause Optical cables are incorrectly connected. The DVD player is not properly set for output. Action Connect the cables correctly. Make the correct output setting. (See the manual for the DVD player.) Understanding auto TA and EQ error messages When correct measurement of car interior acoustic characteristics is not possible using the auto TA and EQ, an error message may appear on the display. If an error message appears, refer to the table below to see what the problem is and the suggested method of correcting the problem. After checking, try again. Message Cause Action Error check MIC Microphone is not connected. Plug the supplied microphone securely into the jack. Error check front SP, Error check FL SP, Error check FR SP, Error check center SP, Error check RL SP, Error check RR SP, Error check subwoofer The microphone cannot pick up the measuring tone of a speaker. ! Confirm that the speakers are connected correctly. ! Correct the input level setting of the power amp connected to the speakers. ! Set the microphone correctly. Error check noise The surrounding noise level is too high. ! Stop your car in a place that is as quiet as possible, and switch off the engine, air conditioner or heater. ! Set the microphone correctly. 22 En