Pioneer DEQ-P8000 Owner's Manual - Page 21
Troubleshooting, Additional Information
UPC - 012562693569
View all Pioneer DEQ-P8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Additional Information Appendix English Troubleshooting Common Symptom Cause Action Power doesnt turn on. No functions come on. Cables or connectors are not correctly connected. Check whether the cables are plugged in correctly and firmly. The fuse is blown. Rectify the reason for the fuse blowing, then replace the fuse. Be very sure to install the correct fuse with the same rating. No sounds are heard. The volume level will not rise. Cables are not connected correctly. Connect the cables correctly. The front, rear, left and right speak- Adjust the relative levels between the speakers are not properly adjusted in level ers correctly. (Page 9) balance. Sound is not heard over a speci- The speaker size is set to OFF. fic speaker. Make the correct size setting for the speaker. (Page 12) The speaker level is set too low. Increase the speaker level setting to get the balance right with the other speakers. (Page 13) The center speaker size is set to Set the center speaker size to OFF. (Page 12) SMALL or LARGE whereas no cen- ter speaker is installed. Audio/DSP Symptom Cause Action Speakers are not available to be Their size settings is at OFF. adjusted. Make the correct size settings. (Page 12) Time alignment is not available. Listening position is not set correctly. Set listening position correctly. (Page 9) Their size settings is at OFF. Make the correct size settings. (Page 12) The subwoofer is not available to The subwoofer is set to OFF. switch its phase. Set the subwoofer to ON. (Page 12) Bass content is not heard. The subwoofer is set to OFF and yet Make the correct settings. (If no subwoofer is other speakers are set to OFF or installed, the front or rear speaker needs to SMALL in size. be set to LARGE.) (Page 12) Ocassionally no sounds are out- The center speaker setting is at put when Dolby Pro Logic is SMALL or LARGE whereas no cen- turned on. ter speaker is installed. Change the center speaker size setting to OFF. (If the audio source is mono and Dolby Pro Logic B is turned on, sound is heard over the center speaker only.) (Page 12) Occasionally no sounds are Dolby Pro Logic B is turned on. heard over speakers other than the center one. Turn Dolby Pro Logic B off. (If the audio source is mono and Dolby Pro Logic B is turned on, sound is heard over the center speaker only.) (Page 11) Turning dynamic range control The currently reproduced sound is The feature is only effective on Dolby Digital on has no effects. not Dolby Digital coded. sounds. (Page 10) En 21