Pioneer DV-363-K Owner's Manual - Page 15

Connecting up 02 1 Connect the VIDEO OUT and AUDIO OUT L/R jacks to a set of A/V inputs on your TV. Use the supplied audio/video cable, connecting the red and white plugs to the audio outputs and the yellow plug to the video output. Make sure you match up the left and right audio outputs with their corresponding inputs for correct stereo sound. See below if you want to use a component or S-video cable for the video connection. 2 Connect the supplied AC power cable to the AC IN inlet, then plug into a power outlet. Connecting using the S-video output If your TV (or other equipment) has an S-video input, you can use this instead of the standard (composite) output for a better quality picture. • Use an S-video cable (not supplied) to connect the S-VIDEO OUT to an S-video input on your TV (or monitor or AV receiver). Line up the small triangle above the jack with the same mark on the plug before plugging in. • Before unplugging the player from the power outlet, make sure you first switch it into standby using either the front panel STANDBY/ON button, or the remote control, and wait of the -OFF- message to disappear from the player's display. • For the above reasons, do not plug this player into a switched power supply found on some amplifiers and AV receivers. • When Component Out (page 50) is set to Progressive, there is no video output from the VIDEO OUT (composite) and S (S-video) jacks. If you want to display video on more than one monitor simultaneously, make sure that it is set to Interlace. Switch the player to standby then, using the front panel controls, press STANDBY/ON while pressing to switch the player back to Interlace. S-VIDEO IN TV DIGITAL AUDIO OUT Y PB COAXIAL AUDIO OUT L OPTICAL R PR S COMPONENT VIDEO OUT VIDEO OUT 15 En